Chevrolet Sonic Repair Manual: Door Lock and Ignition Lock Folding and Non-Folding Key Cutting
High Security keys are available from the service parts system.
Obtain the key code from the security card or from the GM Dealer World, Parts, Key Code Look Up system.
If you have the key code and access to a Triax-E., BD Laser or other code key cutting machine from the GM Dealer Equipment Catalog, you may cut a new key.
If you have the original key and access to a Matrix S, BD Laser or other key duplicating machine, you may duplicate the key.
If you do not have a high security key cutting machine, order the side cut key from the service parts system. Include the key code in the NOTE field. Indicate the timing and the method of the shipment.
Inspect the new key operation in the lock cylinder. Ensure the new key operates effectively.
Door Lock and Ignition Lock Folding Key Blade Removal and Installation
Special Tools
BO-51098 Flip Key Blade Fixture
For equivalent region tools, refer to Special Tools.
Caution: Failure to properly support the Remote Keyless Entry
(RKE) transmitt ...
Rear Door Lock Cylinder Replacement
Rear Door Lock Cylinder Replacement
Callout
Component Name
1
Rear Side Door Lock Cylinder Opening Cover Screw Access Plu ...
Other materials:
Emergency Trunk Release Handle
Caution
Do not use the emergency trunk release handle as a tie-down or anchor point
when securing items in the trunk as it could damage the handle.
There is a glow-in-the-dark emergency trunk release handle on the underside of
the trunk lid. This handle will glow following exposure to light. ...
Tire Inflation Description
When you inflate the tires to the recommended inflation pressures, the factory-installed
wheels and tires are designed in order to handle loads to the tire's rated load
capacity. Incorrect tire pressures, or under-inflated tires, can cause the following
conditions:
Vehicle handling co ...
Piston and Connecting Rod Assemble
Special Tools
EN-49941 Remover / Installer Piston Retainer Ring
For equivalent regional tools, refer to Special Tools.
Note: Lubricate the piston pin with clean engine oil.
Install the connecting rod (3) and the piston pin (2) to the piston (1).
Install t ...
0.006