Callout |
Component Name |
---|---|
Preliminary Procedures
|
|
1 |
Engine Oil Cooler Outlet Pipe Fasteners (Qty: 2) Caution: Refer to Fastener Caution.
8 Y (71 lb in) |
2 |
Seals Note: Replace with NEW seals. |
3 |
Engine Oil Cooler Outlet Pipe |
Air Vents
Use the air vents located in the center and on the side of the instrument panel
to direct the airflow. Move the slats on the center air vents to direct airflow.
Turn the knobs on the side air vents counterclockwise or clockwise to open or
close off the airflow.
Operation Tips
Clear away an ...
Master Cylinder Reservoir Filling
Warning: Refer to Brake Fluid Irritant Warning.
Caution: Refer to Brake Fluid Effects on Paint and Electrical Components
Caution.
Visually inspect the brake fluid level through the brake master cylinder
reservoir.
If the brake fluid level is at or below the half-full point ...
Front Wheel Drive Shaft Outer Joint and Boot Replacement
Special Tools
DT-35910 Drive Axle Boot Clamp Pliers
For equivalent regional tools, refer to Special Tools
Disassemble Procedure
Remove the wheel drive shaft from the vehicle. Refer to Front Wheel
Drive Shaft Replacement.
Install the drive axle shaft (1) i ...