|
Scan Tool Name |
Component Code / Schematic Name |
Service Name |
Repair Instruction Name |
|---|---|---|---|
|
A/C Compressor Clutch |
Q2 A/C Compressor Clutch |
Air Conditioning Clutch |
Air Conditioning Clutch Assembly Replacement |
|
A/C Evaporator Temperature Sensor |
B39 A/C Evaporator Temperature Sensor |
Air Conditioning Evaporator Temperature Sensor |
Evaporator Air Temperature Sensor Replacement |
|
A/C High Side Pressure Sensor |
B1 A/C Refrigerant Pressure Sensor |
A/C Refrigerant Pressure Sensor |
Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement |
|
Air Inlet |
M4 Air Inlet Door Actuator |
Air Inlet Valve Actuator |
Air Inlet Valve Actuator Replacement |
|
Blower Motor |
M8 Blower Motor |
Blower Motor |
Blower Motor Replacement |
|
Blower Motor Resistor |
R3 Blower Motor Resistor |
Blower Motor Resistor |
Blower Motor Resistor Replacement |
|
Remote Heater and Air Conditioning Control Module |
K33 HVAC Control Module |
Heater and Air Conditioning Control |
Heater and Air Conditioning Control Replacement |
General
HVAC System Control Module Programming and SetupIgnition and Start Switch Replacement
Ignition and Start Switch Replacement
Callout
Component Name
Preliminary Procedures
Disconnect the battery negative cable. Refer to Battery Negative
Cable Disconnection and Connection.
Remove the ignition and start switch ...
Camshaft Cover Removal
Remove the oil level indicator (1).
Remove the 15 camshaft cover bolts (1).
Remove the camshaft cover (2) and the camshaft cover gasket (3).
...
Neutral - Engine Running (Gen 1)
When the gear selector is moved to the Neutral (N) position, the hydraulic and
electrical system operation is identical to Park (P) range. However, if Neutral
is selected after the vehicle was operating in Reverse (R), the normally-high 35R
pressure control solenoid 2 is commanded OFF and the ...