Chevrolet Sonic manuals

Chevrolet Sonic Owner's Manual: Power Door Locks

Select and the following may display:

Auto Door Unlock

Select to set which of the doors will automatically unlock when the vehicle is shifted into P (Park).

Select All Doors, Driver Door, or Off.

Unlocked Door Anti Lock Out

When on, this feature will keep the driver door from locking when the door is open. If Off is selected, the Delayed Door Lock menu will be available and the door will lock as programmed through this menu.

Select On or Off.

Delayed Door Lock

When on, this feature will delay the locking of the doors until five seconds after the last door is closed. Three chimes will signal that delayed locking is in use. Pressing either on the RKE transmitter twice will override or
the delayed locking feature and immediately lock all of the doors. Select On or on the RKE transmitter twice will override
the delayed locking feature and immediately lock all of the doors. Select On or Off.

Lighting
Select and the following may display: Exit Lighting Vehicle Locator Lights Exit Lighting Select to set how long the exterior lamps stay on when leaving the vehicle and it is dark outside. ...

Lock, Unlock Settings
Select and the following may display: Remote Unlock Light Feedback Remote Lock Light & Horn Feedback Remote Door Unlock Remote Unlock Light Feedback When on, the exterior lamps will fla ...

Other materials:

Headlining Trim Panel Replacement (Sedan without Sunroof)
Headlining Trim Panel Replacement Callout Component Name Warning: Do not attempt to repair or alter the head impact energy-absorbing material glued to the headliner or to the garnish trims. If the material is damaged ...

Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the proper calibration software. The module stores and utilizes this information however if it is not properly configured with the correct calibration software, the seat heating control module will not control all of the vehicle features ...

Drive Range, First Gear Engine Braking (Gen 1)
When the gear selector lever is moved to the Drive (D) range from the Neutral (N) position, the transmission will provide engine braking. In this operating range, the normally-low 1234 pressure control solenoid 5 is commanded ON and, in the engine braking mode, the following changes occur with ...

В© 2014-2026 Copyright www.csmans.com
 
0.0053