Chevrolet Sonic Owner's Manual: Rear Window and Outside Mirror Defogger
(Rear Window Defogger): Press to
turn the rear window and outside mirror defogger on or off. An indicator light comes
on to show that the feature is on.
The rear window defogger turns off after about 10 minutes. It can also be turned
off by pressing again or by turning
the ignition to ACC/ ACCESSORY or LOCK/OFF. If turned on again it runs for about
five minutes before turning off.
If equipped with heated outside rearview mirrors, they turn on with the rear window defogger and help to clear fog or frost from the surface of the mirror. See Heated Mirrors.
Caution
Using a razor blade or sharp object on the inside rear window can damage the antenna or defogger. Repairs would not be covered by the vehicle warranty. Do not stick anything to the rear window.
Climate Control Systems
These climate control systems control the heating, cooling, and ventilation for
the vehicle.
Climate Control System with Heater and Air Conditioning
1. Temperature Control
2. Fan Control
3. Ai ...
Air Vents
Use the air vents located in the center and on the side of the instrument panel
to direct the airflow. Move the slats on the center air vents to direct airflow.
Turn the knobs on the side air vents ...
Other materials:
Stationary Window Waterleak Repair
Warning: If any water enters the vehicle interior up to the level
of the carpet or higher and soaks the carpet, the sensing and diagnostic module
(SDM) and the SDM harness connector may need to be replaced. The SDM could be
activated when powered, which could cause deployment of the air ...
Rear Side Door Window Regulator Motor Replacement
Rear Side Door Window Regulator Motor Replacement
Callout
Component Name
Warning: Refer to Glass and Sheet Metal Handling Warning.
Preliminary Procedure
Remove the rear side door window regulator. Refer to Rear ...
Tire-to-Wheel Match-Mounting (Vectoring)
Note: After remounting a tire to a wheel or after replacing a tire
and/or a wheel, remeasure the tire and wheel assembly runout in order to verify
that the amount of runout has been reduced and brought to within tolerances.
Ensure that the tire and wheel assembly is properly balanced ...
0.0071