Chevrolet Sonic Owner's Manual: Sheet Metal Damage
If the vehicle is damaged and requires sheet metal repair or replacement, make sure the body repair shop applies anti-corrosion material to parts repaired or replaced to restore corrosion protection.
Original manufacturer replacement parts will provide the corrosion protection while maintaining the vehicle warranty.
Underbody Maintenance
At least twice a year, Spring and Fall, use plain water to flush dirt and debris
from the vehicle's underbody. Your dealer or an underbody car washing system can
do this. If not removed, rust ...
Finish Damage
Quickly repair minor chips and scratches with touch-up materials available from
your dealer to avoid corrosion. Larger areas of finish damage can be corrected in
your dealer's body and paint s ...
Other materials:
Fog Lamps (RS)
To replace the front fog lamp bulb:
Locate the fog lamp located under the front fascia.
Remove the cap from the back of the fog lamp assembly.
Disconnect the electrical connector from the fog lamp bulb assembly.
Remove the bulb by turning it counterclockwise and pulling it straight out ...
Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the proper calibration
software. The module stores and utilizes this information however if it is not properly
configured with the correct calibration software, the seat heating control module
will not control all of the vehicle features ...
Manual Transmission Shift Lever and Selector Lever Cable Adjustment
Remove the floor console. Refer to
Front Floor Console Replacement.
Lift upward and disengage (do not remove) both cable lock
adjusters (1) to release the internal cable assembly, one for each side.
Block the shift control housing, push the selector lever ( ...
0.0052