Chevrolet Sonic Repair Manual: Transmission Fluid Pump, Front Differential Carrier Baffle, and Front Differential Ring Gear Installation (6T40/45)
|
Callout |
Component Name |
|---|---|
|
1 |
Torque Converter and Differential Housing Seal |
|
2 |
Fluid Pump Assembly |
|
3 |
Fluid Pump Bolts M8 x 33 (Qty: 8) Caution: Refer to Fastener Caution.
10 Y (89 lb in) then rotate the bolt an additional 45 degrees Special Tool
EN-45059 Angle Meter or equivalent For equivalent regional tools, refer to Special Tools. |
|
4 |
Front Differential Ring Gear |
|
5 |
Front Differential Ring Gear Retainer Note: Install the retainer with the taper facing away from the ring gear. |
|
6 |
Front Differential Carrier Baffle |
|
7 |
Front Differential Carrier Baffle Bolts M6 x 25 (Qty: 2) Tighten
12 Y (106.21 lb in) |
Transmission Fluid Pump, Front Differential Carrier Baffle, and Front Differential
Ring Gear Installation (6T30)
Transmission Fluid Pump, Front Differential Carrier Baffle, and Front
Differential Ring Gear Installation
Callout
Component Name
...
Transmission Fluid Pump, Front Differential Carrier Baffle, and Front Differential
Ring Gear Removal (6T30)
Transmission Fluid Pump, Front Differential Carrier Baffle, and Front
Differential Ring Gear Removal
Callout
Component Name
1
...
Other materials:
Towing the Vehicle
Caution
Incorrectly towing a disabled vehicle may cause damage. The damage would not
be covered by the vehicle warranty. Do not lash or hook to the chassis components
— including the front and rear subframes, suspension control arms, and links — during
towing and recovery of a disabled ve ...
Traction Control System (TCS)/StabiliTrak® Light
The StabiliTrak or Traction Control System (TCS) indicator/warning light comes
on briefly when the engine is started.
If the light does not come on, have the vehicle serviced by your dealer. If the
system is working normally, the indicator light turns off.
If the light is on and not flashing ...
Lock Cylinder Coding - Ignition
The ignition lock cylinder uses 8 key cut positions, 1–8. The ignition cylinder
tumblers (3) are located on alternate sides of the cylinder (5). They are not snap-in
and are not self-retaining. It follows the key code with the first tumbler being
the first depth of the ...