Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Windshield Washer Solvent Container Replacement

Chevrolet Sonic Repair Manual / Body / Wipers, Washers / Washer Fluid System / Windshield Washer Solvent Container Replacement



Windshield Washer Solvent Container Replacement

Callout

Component Name

Preliminary Procedures

  1. Remove the windshield washer solvent container filler tube. Refer to Windshield Washer Solvent Container Filler Tube Replacement.
  2. Remove the left side front portion of the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement.
  3. Disconnect the windshield washer hose from the windshield washer solvent container washer pump hose.
  4. Disconnect the windshield washer pump electrical connector from the washer pump.

1

Windshield Washer Solvent Container Washer Pump Hose

Procedure

Disengage the washer pump hose from the washer pump spout and the windshield washer container retention tabs.

2

Windshield Washer Solvent Container Nut (Qty:?€‰3)

Caution:

Refer to Fastener Caution.

Tighten


5.0?€‰Y (44?€‰lb?€‰in)

3

Windshield Washer Solvent Container

Procedure

  1. Remove the windshield washer solvent container from the three studs on the front compartment front outer side rail and battery tray support.
  2. Remove the windshield washer pump from the windshield washer solvent container.
  3. Empty the windshield washer solvent into a suitable approved clean container.
  4. Transfer parts as needed.
Windshield Washer Solvent Container Hose Replacement
Windshield Washer Solvent Container Hose Replacement Callout Component Name Preliminary Procedure Remove the left front wheelho ...

Rear Window Washer Nozzle Replacement
Rear Window Washer Nozzle Replacement Callout Component Name Preliminary Procedure Remove the inside high mount stop lamp. Refe ...

Other materials:

Shoulder Belt Height Adjuster
The vehicle has a shoulder belt height adjuster for the driver and right front passenger seating positions. Adjust the height so the shoulder portion of the belt is on the shoulder and not falling off of it. The belt should be close to, but not contacting, the neck. Improper shoulder belt hei ...

Timing Belt Replacement
Special Tools EN-6333 Timing Belt Tensioner Locking Pin EN-6340 Camshaft Locking Tool For equivalent regional tools, refer to Special Tools. Removal Procedure Note: If the timing belt is being replaced due to the maintenance schedule interval, then the timing belt t ...

Fuel Feed Pipe Replacement
Removal Procedure .- Remove the fuel feed pressure sensor. Refer to Fuel Pressure Sensor Replacement - Fuel Feed Pipe. Disconnect the fuel feed pipe (1). Refer to Plastic Collar Quick Connect Fitting Service. Remove the plastic retainer (1) ...

© 2014-2020 Copyright www.csmans.com
   
0.0136