Chevrolet Sonic Repair Manual: Airbag Side Impact Sensor Replacement (with AYF/AYO)

Chevrolet Sonic Repair Manual / Body / Restraints / Air Bag Modules / Airbag Side Impact Sensor Replacement (with AYF/AYO)

Airbag Side Impact Sensor Replacement
Callout	Component Name
Warning: Refer to SIR Warning. Warning: Refer to SIR Inflator Module Handling and Storage Warning. Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary: The seat cushion frame The seat recliner, if equipped The seat adjuster The seat back frame Failure to do so may cause future personal injury. Preliminary Procedures Disable the SIR system. Refer to SIR Disabling and Enabling. Remove the center pillar lower trim panel. Refer to Center Pillar Lower Trim Panel Replacement.
1	Inflatable Restraint Side Impact Sensor Assembly Caution: Refer to Fastener Caution. Procedure Disconnect electrical connector. Loosen the fasteners and slide the sensor out of the keyhole slots. The bolts are integral to the sensor assembly, DO NOT remove separately. Tighten 7.5?€‰Y (66?€‰lb?€‰in)

Airbag Sensing and Diagnostic Module Replacement

Airbag Sensing and Diagnostic Module Replacement Callout Component Name Warning: Refer to SIR Warning. Warning: D ...

Airbag Steering Wheel Module Coil Centering

Note: If a double wire harness strap is installed onto the wire harness assembly and steering column, the original holder for the wire strap(s) MUST be reused during installation. ...

Other materials:

SIR Service Precautions
General Service Instructions Warning: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling . Failure to observe the correct procedure could cause deployment of the SIR components, person ...

Water Outlet Installation
Clean the sealing surfaces. Install the water outlet (2) and a NEW water outlet seal ring (1). Caution: Refer to Fastener Caution. Install the 3 water outlet bolts (3) and tighten to 8 Y (71 lb in). ...

Secondary Air Injection System Description
The Secondary Air Injection System aids in the reduction of hydrocarbon exhaust emissions during a cold start. This occurs when the start-up engine coolant temperature (ECT) is between −10 to +56°C (14?E33°F), the intake air temperature (IAT) is greater than −10°C (14°F) and it ...

0.0057