|
Callout |
Component Name |
|---|---|
|
Warning: Refer to SIR Warning. Warning: Refer to SIR Seatbelt Pretensioner Handling Warning. Warning: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws.
|
|
|
1 |
Front Seat Belt Anchor Plate Fastener Caution: Refer to Fastener Caution.
8?€‰Y?€‰(70?€‰lb?€‰in) |
|
2 |
Front Seat Belt Retractor D Ring Fastener Tighten
45?€‰Y?€‰(33?€‰lb?€‰ft) |
|
3 |
Front Seat Shoulder Belt Guide Retainer |
|
4 |
Front Seat Shoulder Belt Retractor Fastener Tighten
45?€‰Y?€‰(33?€‰lb?€‰ft) Note: When the seat belt retractor is replaced with a new one, there is no thread in the nut welded to the retractor. This is normal as the bolt will make the thread in the welded nut when the bolt is tightened. |
|
5 |
Front Seat Shoulder Belt Assembly |
Driver or Passenger Seat Shoulder Belt Replacement (with A69)
Front End Inflatable Restraint Discriminating Sensor ReplacementInstrument Panel Compartment Door Latch Replacement
Instrument Panel Compartment Door Latch Replacement
Callout
Component Name
1
Instrument Panel Compartment Door Latch Fasteners (Qty:?€‰2)
Caution: Refer to Fastener Caution.
2
...
Driver Information Center (DIC)
The DIC displays information about your vehicle. It also displays warning messages
if a system problem is detected. See Vehicle Messages. All messages appear in the
DIC display in the instrument cluster.
DIC Operation and Displays
The DIC has different displays which can be accessed b ...
Radiator Inlet Hose Replacement (LDE LUW)
Special Tools
BO-38185 Hose Clamp Pliers
For equivalent regional tools, Refer to Special Tools.
Removal Procedure
Drain the cooling system. Refer to Cooling System Draining and Filling.
Remove the radiator inlet hose clamp (1) at the engine using BO-38185 ...