|
Callout |
Component Name |
|---|---|
|
1 |
Fuel Tank Filler Door Procedure
Position the fuel tank filler door to the full open position. Using light outward sliding pressure on the filler door, release the retainer on the fuel tank filler door from the hinge. |
Front and Rear Side Door Sill Trim Plate Kit Installation
Fuel Tank Filler Door ReplacementTaillamps, Turn Signal, Stoplamps, and Back-Up Lamps
Sedan Taillamp Shown, Hatchback Taillamp Similar
Back-up Lamp
Turn Signal Lamp
Stop Lamp/Taillamp
Sidemarker Lamp
To replace one of these bulbs:
Open the trunk.
Remove the two screws, which secure the taillamp assembly.
Remove the taillamp assembly by pulling it straight ...
Engine Component Description
Cylinder Block
The cylinder hollow frame structured in–line 4 cylinder. The block has 5 crankshaft
bearings with the thrust bearing located on the third bearing from the front
of the engine.
Crankshaft
The crankshaft is a steel crankshaft. It is supported ...
Input Shaft Support Replacement (Gen 2)
Input Shaft Support Replacement
Callout
Component Name
1
3-5 Reverse and 4-5-6 Clutch Fluid Seals (Qty: 3)
Note:
Discard the fluid seals. They are not reusable.
Refer to 3-5-Reverse an ...