Chevrolet Sonic manuals

Audi Q7 (4M) 2016-2022 Owner's Manual: Jump starting

Preparation

You should only perform the steps that follow if you have the necessary tools and technical expertise.

If the engine does not start because the vehicle battery is drained, you can jump start your vehicle using another vehicle. Jump start cables are needed to do this.

Both vehicle batteries must have 12 V nominal voltage. The voltage capacity (Ah) of the vehicle battery that is giving power must not be less than the capacity of the drained vehicle battery.

Jump start cable

Only use a jump start cable with a large enough diameter. Note the manufacturer's specifications.

Only use a jump start cable with insulated terminal clamps.

Positive cable - usually red.

Negative cable - usually black.

WARNING

Note

Jump start cables can cause considerable damage to the vehicle electrical system if they are connected incorrectly.

Tips

Jump starting

Both jump start cables must be connected in the correct order.


Fig. 185 Engine compartment: connectors for jump start cables or a charger


Fig. 186 Connecting the jump start cables

The jump start cable connections are located in the engine compartment.

Follow the information about the vehicle battery.

Connecting the positive cable (red) to the positive terminal

  1. Attach one end of the positive cable (red) to the jump-start pin (1) > fig. 186 on your vehicle.
  2.  Attach the other end of the positive cable (red) to the positive terminal (2) on the power source.

Connecting the negative cable (black) to the negative terminal

  1. Attach one end of the negative cable (black) to the negative terminal (3) on the power source.
  2. Attach the other end of the negative cable (black) to the jump-start pin (4) on the vehicle.

Starting the engine

WARNING

Note

Please note that the connecting process previously described for the jump start cables is intended for when your vehicle is being jump started.

Tips

Make sure that the connected jump start cables have sufficient contact with metal.

Raising the vehicle
Applies to: vehicles with vehicle jack Fig. 181 Sill panels: markings Fig. 182 Sill: positioning the vehicle jack Place the vehicle jack from the vehicle tool kit on a firm surface. Use a flat, ...

Towing
General information You should only perform the steps that follow if you have the necessary tools and technical expertise. Towing requires a certain amount of practice. Audi recommends contacting a t ...

Other materials:

Front Seat Belt Anchor Plate Tensioner Replacement
Front Seat Belt Anchor Plate Tensioner Replacement Callout Component Name Warning: Refer to SIR Warning. Warning: In order to prevent accidental deployment and the risk of personal injury, do not dispose of a ...

SIR Identification Views
The SIR Identification Views shown below illustrate the approximate location of all SIR components available for the vehicle. This will assist in determining the appropriate SIR Disabling and Enabling for a given service procedure, refer to SIR Disabling and Enabling. Supplemental Inf ...

3-5-Reverse and 4-5-6 Clutch Housing Assemble (6T30/40/45/50 - Gen 2)
Table 1: 4?? Clutch Piston Installation Table 2: 4?? Clutch Fluid Dam Installation Table 3: 3? Reverse Clutch Plates Installation Table 4: Reluctor Wheel and Piston Installation Table 5: 4?? Clutch Plates Installation Table 6: ...

© 2014-2022 Copyright www.csmans.com
 
0.01