Chevrolet Sonic manuals

Audi Q7 (4M) 2016-2022 Owner's Manual: Laser lighting

Applies to: vehicles with laser lighting

Fig. 36 Headlights: label
Fig. 36 Headlights: label

The laser lights increase the range of the headlights.

An additional module integrated in the headlight converts a blue laser light into a white light using a luminescent material.

Activating or deactivating laser lights

Requirement: the AUTO light function must be set, and the high beam assistant and the laser lights must be switched on in the MMI.

The high beam is controlled by the high beam assistant.

The laser lights switch on shortly after the LED high beams are switched on.

The laser lights are switched on at speeds above approximately 44 mph (70 km/h) when the high beams are switched on. The indicator light will turn on if the high beams are switched on.

The indicator light turns on if the laser lights are switched on.

The laser lights are switched off when the speed decreases below approximately 30 mph (50 km/h) or when the high beam assistant switches the LED headlights off.



Adjusting the exterior lighting

You can adjust the exterior lighting separately.

The settings depend on the vehicle equipment.

Automatic headlights

You can adjust the following settings in the Automatic headlights menu:

Activation time - You can adjust if the headlights switch on Early, Medium, or Late based on the sensitivity of the light sensor.

High beam assistant - You can switch the high beam assistant on and off.

Laser lights - You can switch the laser lights on and off.

Entry/exit lighting

The Entry/exit lighting illuminates the area around the vehicle when the vehicle is unlocked or when the driver's door is opened while the ignition is off. The entry/exit lighting works when it is dark and the light switch is in the AUTO position.

The front and rear daytime running lights* switch on automatically each time the vehicle is unlocked regardless of how bright it is outside the vehicle.

Daytime running lights

USA models: The daytime running lights can be switched on and off.

Canada models: This function cannot be switched off. They activate automatically each time the ignition is switched on.

Turn signal and high beam lever
Fig. 35 Operating lever: switching the light functions on and off The lever operates the turn signals, the high beams and the headlight flasher. Turn signals The turn signal will activate when you ...

Emergency flashers
Fig. 37 Center console: emergency flashers The emergency flashers help to make other drivers aware of your vehicle in dangerous situations. Press the (1) button to switch the emergency flasher ...

Other materials:

Checking Coolant
The vehicle must be on a level surface when checking the coolant level. It is normal to see coolant moving in the upper coolant hose return line when the engine is running. Check to see if coolant is visible in the coolant surge tank. If the coolant inside the coolant surge tank is boiling, do ...

Front Seat Cushion Outer Trim Panel Replacement
Front Seat Cushion Outer Trim Panel Replacement Callout Component Name Preliminary Procedures Remove the driver or passenger seat recliner handle. Refer to Front Seat Back Recliner Handle Replacement Remove the front seat ...

Engine Oil Pressure Indicator Switch Replacement
Engine Oil Pressure Indicator Switch Replacement Callout Component Name Preliminary Procedure Remove the air conditioning compressor. Refer to Air Conditioning Compressor Replacement. 1 Oil Pres ...

В© 2014-2022 Copyright