Chevrolet Sonic Repair Manual: Rear Side Door Stationary Window Replacement

Chevrolet Sonic Repair Manual / Body / Glass & Windows / General / Rear Side Door Stationary Window Replacement

Rear Side Door Stationary Window Replacement
Callout	Component Name
Warning: Refer to Glass and Sheet Metal Handling Warning. Preliminary Procedures Remove the rear side door window. Refer to Rear Side Door Window Replacement.
1	Rear Side Door Window Weatherstrip Lower Bolt Caution: Refer to Fastener Caution. Tighten 9?€‰Y (80?€‰lb?€‰in) Tip: The weatherstrip and window is serviced as one assembly.
2	Rear Side Door Window Weatherstrip Upper Screw Procedures Pull the weatherstrip out of the upper retainer to expose the screw. Remove the weatherstrip from the front and rear lower guides. Grasp both upper corners, pull forward releasing assembly from the door frame. Tighten 3?€‰Y (27?€‰lb?€‰in)
3	Rear Side Door Window Weatherstrip Procedures Insert the weatherstrip downward in the guide until fully seated. Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the guides. Inspect the door window for proper operation before installing the door trim panel.

Liftgate Window Replacement

Special Tools BO-24402-A Glass Sealant Remover (Cold Knife) BO-39032 Stationary Glass Removal Tool Use an adhesive that is approved by GM For equivalent regional tools, refer to Special Too ...

Rear Side Door Window Outer Sealing Strip Replacement (Hatchback)

Rear Side Door Window Outer Sealing Strip Replacement Callout Component Name 1 Rear Side Door Window Outer Sealing Strip ...

Other materials:

Where Are the Airbags?
The driver frontal airbag is in the center of the steering wheel. The front outboard passenger frontal airbag is in the passenger side instrument panel. The driver knee airbag, if equipped, is below the steering column. The front outboard passenger knee airbag, if equipped, is below the gl ...

Instrument Panel Center Upper Molding Replacement
Instrument Panel Center Upper Molding Replacement Callout Component Name Preliminary Procedure Remove the instrument panel center molding. Refer to Instrument Panel Center Molding Replacement. 1 ...

Special Tools
Illustration Tool Number/Description 3-9607433 Transmission Support DT-586 J-23129 KM-586 Universal Seal Remover DT-3289-20 J-3289-20 Holding Fixture ...

0.0068