Chevrolet Sonic manuals

Audi Q7 (4M) 2016-2022 Owner's Manual: Turn signal and high beam lever

Fig. 35 Operating lever: switching the light functions on and off
Fig. 35 Operating lever: switching the light functions on and off

The lever operates the turn signals, the high beams and the headlight flasher.

Turn signals

The turn signal will activate when you move the lever into a turn signal position while the ignition is switched on. The respective or indicator light will flash. The turn signal blinks three times if you tap the lever (convenience turn signal).

  1. Right turn signal
  2. Left turn signal

If an indicator light blinks twice as fast as usual, a turn signal bulb has failed. Carefully drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have the malfunction corrected.

High beams and headlight flasher

Move the lever to the corresponding position:

  1. High beams on (vehicles with High beam assistant*
  2. High beams off or headlight flasher

The indicator light in the instrument cluster will turn on.

WARNING

High beams can cause glare for other drivers, which increases the risk of an accident. For this reason, only use the high beams or the headlight flasher when they will not create glare for other drivers.

High beam assistant

The high beam assistant automatically turns the high beams on or off depending on the surrounding conditions.

A camera on the rearview mirror mount can detect light sources from other road users. The high beams switch on or off automatically depending on the position of vehicles driving ahead and oncoming vehicles, the vehicle speed as well as other environmental factors and traffic conditions.

Activating high beam assistant

Requirement: the light switch must be in the AUTO position and the high beam assistant must be switched on in the MMI.

Activating and deactivating the high beam head lights manually

If the high beams did not switch on or off as expected, you may switch them on or off manually instead:

Operating the headlight flasher

WARNING

Tips

Adhere to any local applicable regulations when using the lighting equipment, for example in regard to reducing glare for other drivers.

The driver is always responsible for adhering to the regulations applicable in the country where the vehicle is being operated.

Exterior lighting
Switching the lights on and off Fig. 34 Instrument panel: light button module Light switch Press and hold (1) until the desired light function is selected. The selected function is displayed bri ...

Laser lighting
Applies to: vehicles with laser lighting Fig. 36 Headlights: label The laser lights increase the range of the headlights. An additional module integrated in the headlight converts a blue laser lig ...

Other materials:

Brake Fluid Level Indicator Switch Replacement
Removal Procedure Disconnect the brake fluid level indicator switch electrical connector. Using a small, flat-bladed tool, lift the locking tab on the underside of the brake fluid level indicator switch (1) and remove the switch. Inspect the maste ...

Horn Replacement
Horn Replacement Callout Component Name Preliminary Procedure Remove the front wheelhouse liner front. Refer to Front Wheelhouse Liner Replacement. 1 Horn Nut Caution: Refer to Fastener ...

Sunroof Switch Replacement
Sunroof Switch Replacement Callout Component Name Preliminary Procedure Remove the dome lamp bezel. Refer to Dome Lamp Bezel Replacement. 1 Sunroof Switch Procedure Disconnect electrical conn ...

В© 2014-2022 Copyright www.csmans.com
 
0.007