Chevrolet Sonic manuals

Audi Q7 (4M) 2016-2022 Owner's Manual: When driving

Starting to drive, stopping, and parking

Starting from a stop

Securing the vehicle against rolling

Secure your vehicle to prevent it from rolling before exiting the vehicle.

If one of these measures is not possible, for example because there is no vehicle power, you must secure your vehicle against rolling using additional measures.

Set the parking brake before selecting the "P" selector lever position. This prevents too much stress from being put on the locking mechanism when parking on a steep surface.

WARNING

Note

If you have to stop on an incline, always press the brake pedal to hold the vehicle in place to reduce the risk of the vehicle rolling backward.

Do not try to hold the vehicle in place by pressing and holding the accelerator pedal.

The transmission can overheat, which increases the risk of damage.

Hill hold assist

If you take your foot off of the brake pedal when driving on hills, the braking force will be held for several seconds. At that time, you can start driving without the vehicle rolling backward.

Requirement: the driver's door must be closed, the engine must be on, and the vehicle must be traveling uphill.

WARNING

Starting the vehicle
Description Fig. 90 Center console: starting the engine Requirement: the key must be in the vehicle. Starting the engine Press and hold the brake pedal. Press the [START ENGINE STOP] button. Th ...

Gears and driving programs
Fig. 91 Center console: selector lever The automatic transmission shifts automatically depending on the selected gear and the current driving style. When driving with a moderate driving style, upshi ...

Other materials:

Cruise Control Description and Operation
Cruise control is a speed control system that maintains a desired vehicle speed under normal driving conditions at speeds above 40 km/h (25 mph). Steep grades may cause variations in the selected vehicle speeds. The following are the main components of the Cruise Control System: ...

Range Selector Lever Cable Adjustment
Note: Adjust the automatic transmission range selector cable while the transmission and the gear selector are in the Park position only. Failure to do so may cause mis-adjustment. Set the park brake and chock the wheels. Verify the transmission range select lever is in the par ...

Engine Replacement (Manual Transmission)
Special Tools J-45859 Wheel Drive Shaft Remover . CH-807 Closure Plugs .  For equivalent regional tools, refer to Special Tools. Removal Procedure Remove the battery and battery tray. Refer to Battery Tray Replacement. Relieve the fuel system pressure. Refer to ...

В© 2014-2022 Copyright www.csmans.com
 
0.0084