Chevrolet Sonic manuals

Audi Q7 (4M) 2016-2022 Owner's Manual: Windshield wipers

Switching the windshield wipers on

Fig. 45 Lever: windshield wipers
Fig. 45 Lever: windshield wipers

Fig. 46 Lever: rear window wiper
Fig. 46 Lever: rear window wiper

Move the lever to the corresponding position:

(0) Windshield wipers off

(1) Rain sensor/intermittent mode. The windshield wipers switch on once the vehicle speed exceeds approximately 2 mph (4 km/h) and it is raining. The higher the sensitivity of the rain sensor that is set (switch (6) to the right), the earlier the windshield wipers react to moisture on the windshield. You can deactivate the rain sensor mode, which switches the interval mode on. In intermittent mode, you can adjust the interval time using the switch (6).

(2) Slow wiping

(3) Fast wiping

(4) Single wipe. If you hold the lever in this position longer, the wipers switch from slow wiping to fast wiping.

(5) Clean the windshield . The number of wipes and afterwipes depends on how long the lever is held in position (5).

The wipers wipe one time after several seconds of driving to remove water droplets. You can switch this function off by moving the lever to position (5) within ten seconds of the afterwipe. The afterwipe function is reactivated the next time you switch the ignition on.

If you hold the Lever in position (5) for longer than half a second, the edge wiping feature will be activated. This moves the windshield wipers closer to the edge of the windshield and performs an afterwipe to clean the residue that results from the wiping process from the edge of the windshield. The function is available when driving at speeds up to 75 mph (120 km/h).

The headlight washer system* operates only when the low beam headlights are on. If you move the lever into position (5), the headlights will be cleaned at fixed intervals.

(7) Wipe the rear window . The number of wipes depends on the windshield wiper movement.

The rear wiper automatically switches on when the reverse gear is selected and the front windshield wipers are on and running.

(8) Clean the rear window . The number of wipes depends on how long the lever is held in position (8). This may also clean the rearview camera, depending on the vehicle equipment.

WARNING

Note

Tips

Vision
Adjusting exterior mirrors Fig. 41 Driver's door: knob for the exterior mirrors Turn the knob in the driver's door to the desired position: 0 - Deactivates all adjustment functions. - Selects the l ...

Cleaning/changing wiper blades
Fig. 47 Windshield wipers: changing the wiper blades Wiper blade replacement position Switch off the ignition and hold the windshield wiper lever in position (4), fig. 45 until the windshield wi ...

Other materials:

SIR Disabling and Enabling
SIR component location affects how a vehicle should be serviced. There are parts of the SIR system installed in various locations around a vehicle. To find the location of the SIR components refer to Supplemental Inflatable Restraint System Description and Operation. There are several reason ...

Warm Up Three-Way Catalytic Converter Removal
Disconnect the heated oxygen sensor wiring harness (3) from retainer clip. Remove the 2 catalytic converter to catalytic converter bracket nuts (4) and (6). Loosen the three way warm up catalytic converter V-clamp (1). Remove the three way warm up ...

Piston, Connecting Rod, and Bearing Removal
Install the crankshaft balancer bolt. Set the pistons 1 and 4 to TDC in direction of engine rotation. Note: Note cylinder sequence. Mark the connecting rod with the connecting rod bearing cover (1). Remove the 4 connecting rod bearing caps bol ...

В© 2014-2022 Copyright www.csmans.com
 
0.0091