Chevrolet Sonic Repair Manual: 2-6 Clutch Piston Installation (6T30)

Chevrolet Sonic Repair Manual / Powertrain / Engine / Engine Block / Cylinder Block / 2-6 Clutch Piston Installation (6T30)

2-6 Clutch Piston Installation
Callout	Component Name
1	2?E Clutch Piston Assembly Note: Position the 2?E piston air bleed and large slot toward the top of the case. DT-48271 seal protector prevents the piston seal lip from damage during installation. Apply a thin coat of ATF to the I.D. of the DT-48271 seal protector to ease installation of the piston. Special Tool DT-48271 Seal Protector For equivalent regional tools, refer to Special Tools.
2	2?E Clutch Spring
3	2?E Clutch Spring Retainer Caution: Regulate the air pressure to 276 kPa (40 psi) maximum. High pressure could cause the piston to over travel and damage the piston seals. Note: Place the retainer on the 2-6 clutch spring and align the retainer opening with the largest gap in the case splines toward the bottom of the case. The retainer opening should be supported by a spline tooth of the case. Apply shop air to the clutch fluid feed hole in the case to verify proper piston operation. Special Tools DT-48272 Spring Installer DT-48056 Spring Compressor Bridge For equivalent regional tools, refer to Special Tools.

Piston, Connecting Rod, and Bearing Removal

Install the crankshaft balancer bolt. Set the pistons 1 and 4 to TDC in direction of engine rotation. Note: Note cylinder sequence. Mark the connecting rod with the ...

2-6 Clutch Piston Installation (6T40/45/50)

2-6 Clutch Piston Installation Callout Component Name 1 2?E Clutch Piston Assembly Note: Position the ...

Other materials:

Radiator Grille Bumper Replacement
Radiator Grille Bumper Replacement Callout Component Name Preliminary Procedure Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement. 1 Radiator Grille Bumper Screw (Qty:?€� ...

Windshield Wiper Motor Replacement
Windshield Wiper Motor Replacement Callout Component Name Preliminary Procedure Remove the wiper system module. Refer to Windshield Wiper System Module Replacement 1 Windshield Wiper Motor Brack ...

Brake Rotor Assembled Lateral Runout Measurement
Special Tools CH-41013 Rotor Surfacing Kit CH-42450-A Wheel Hub Resurfacing Kit CH-45101 Hub and Wheel Runout Gauge CH-45101-100 Conical Brake Rotor Washers For equivalent regional tools, refer to Special Tools. Warning: Refer to Brake Dust Warning. Note: B ...

0.0081