Chevrolet Sonic Repair Manual: 2-6 Clutch Piston Installation (6T30)

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Automatic / General / 2-6 Clutch Piston Installation (6T30)

2-6 Clutch Piston Installation
Callout	Component Name
1	2? Clutch Piston Assembly Note: Position the 2? piston air bleed and large slot toward the top of the case. DT-48271 seal protector prevents the piston seal lip from damage during installation. Apply a thin coat of ATF to the I.D. of the DT-48271 seal protector to ease installation of the piston. Special Tool DT-48271 Seal Protector For equivalent regional tools, refer to Special Tools.
2	2? Clutch Spring
3	2? Clutch Spring Retainer Caution: Regulate the air pressure to 276 kPa (40 psi) maximum. High pressure could cause the piston to over travel and damage the piston seals. Note: Place the retainer on the 2-6 clutch spring and align the retainer opening with the largest gap in the case splines toward the bottom of the case. The retainer opening should be supported by a spline tooth of the case. Apply shop air to the clutch fluid feed hole in the case to verify proper piston operation. Special Tools DT-48272 Spring Installer DT-48056 Spring Compressor Bridge For equivalent regional tools, refer to Special Tools.

General

...

2-6 Clutch Piston Installation (6T40/45/50)

2-6 Clutch Piston Installation Callout Component Name 1 2? Clutch Piston Assembly Note: Position the ...

Other materials:

Rear Disc Brake Pads Replacement
Removal Procedure Warning: Refer to Brake Dust Warning. Note: Always replace disc brake pads in axle sets. Inspect the fluid level in the brake master cylinder reservoir. If the brake fluid level is midway between the maximum-full point and the minimum allowab ...

Parking Brake Cable Replacement (Drum Brake)
Removal Procedure Remove the front floor console. Refer to Front Floor Console Replacement. Ensure that the parking brake lever is in the fully released position. Using ONLY HAND TOOLS, remove the adjusting nut (1) from the end of the front park bra ...

Turbocharger Removal
Special Tool EN-49942 Holding Wrench For equivalent regional tools, refer to Special Tools. Install the EN-49942 holding wrench (2) to the turbocharger coolant feed pipe. Guide a ratchet wrench (1) along with an extension through EN-49942 holding wrench to the turbo ...

0.0069