Chevrolet Sonic manuals
 

Chevrolet Sonic Repair Manual: Accessory Power Receptacle Replacement

Chevrolet Sonic Repair Manual / Body / Body Electrical / Accessory Outlets / Accessory Power Receptacle Replacement

Special Tools

EL-42059 Cigar Lighter Socket Remover .

For equivalent regional tools. Refer to Special Tools

Removal Procedure

    Remove the auxiliary power outlet fuse from the fuse block.
  1. Remove the auxiliary power outlet fuse from the fuse block.
  2. Remove the receptacle:
    1. Look into the receptacle. There are two 3?€‰mm (0.11?€‰in) tab windows 12?€‰mm (0.47?€‰in) from the front of the receptacle. The EL-42059 Cigar Lighter Socket Remover pushes the plastic latches from these tab windows and the receptacle can be pulled straight out.
    2. Place one side of the ?€?T?€? portion of the EL-42059 Cigar Lighter Socket Remover into the tab window. The EL-42059 Cigar Lighter Socket Remover will not fit straight into the receptacle. Angle the slightly for insertion into the receptacle.
    3. Insert the other side of the ?€?T?€? into the opposite tab window.

      You must move the EL-42059 Cigar Lighter Socket Remover handle toward horizontal to engage the other tab window.

    4. Use the EL-42059 Cigar Lighter Socket Remover to pull the receptacle straight out.


  3. If EL-42059 Cigar Lighter Socket Remover tool fails to release the lighter socket from the retainer, perform the following alternate method:
    1. Insert a small grinding tool with a cutoff wheel into the socket.
    2. Remove the plastic latches in the 3?€‰mm (0.11?€‰in) square windows.
    3. Use the EL-42059 Cigar Lighter Socket Remover as directed above to remove the socket.
Installation Procedure

    Route the connector through the retainer. Align the accessory power
  1. Route the connector through the retainer. Align the accessory power receptacle retainer to the slot in the opening.
  2. Install the retainer by pressing into place fully seated.
  3. Connect the electrical connector to the receptacle.
  4. Align the tabs on the receptacle to the slots in the retainer. Install the accessory power receptacle by pressing into place until fully seated.
  5. Install the accessory power receptacle fuse.
Accessory Outlets
...

Cigarette Lighter Receptacle Replacement
Special Tools EL-42059 Cigar Lighter Socket Remover . For equivalent regional tools. Refer to Special Tools Removal Procedure Remove the auxiliary power outlet fuse from the ...

Other materials:

Tire Rotation and Required Services Every 12 000 km/ 7,500 mi
Rotate the tires, if recommended for the vehicle, and perform the following services. See Tire Rotation. Check engine oil level and oil life percentage. If needed, change engine oil and filter, and reset oil life system. See Engine Oil  and Engine Oil Life System. Check engine coo ...

Center Pillar Reinforcement Replacement
Removal Procedure Warning: Refer to Approved Equipment for Collision Repair Warning. Warning: Refer to Glass and Sheet Metal Handling Warning. Note: The center pillar upper stiffener is made of Dual Phase Steel and should be replaced only at ...

Engine Block Cleaning and Inspection
Special Tools EN-8087 Cylinder Gauge For equivalent regional tools, refer to Special Tools. Clean the sealing material from the gasket mating surfaces (2). Clean the engine block (1) and lower crankcase in a cleaning tank with solvent appropriate for aluminum. Refer ...

© 2014-2026 Copyright www.csmans.com
 
0.006