Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Air Conditioning (AC) Refrigerant Filter Replacement

Chevrolet Sonic Repair Manual / HVAC / Cooling / Air Conditioning (AC) Refrigerant Filter Replacement

Special Tools

GE 39400-A Halogen Leak Detector

For equivalent regional tools, refer to Special Tools.

Removal Procedure
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
  2. Remove the air conditioning condenser. Refer to Air Conditioning Condenser Replacement.


  3. Note:

    Cap all A/C components immediately to prevent system contamination.

  4. Remove the air conditioning receiver and dehydrator plug (4).
  5. Remove and discard the sealing washers (3).
  6. Remove the refrigerant filter (2) from the condenser (1).
Installation Procedure

    Uncap A/C components.
  1. Uncap A/C components.
  2. Install new sealing washers (3). Refer to Air Conditioning O-Ring Seal Replacement.
  3. Install the refrigerant filter (2) into the air conditioning condenser (1).
  4. Install the air conditioning receiver and dehydrator plug (4).
  5. Install the air conditioning condenser. Refer to Air Conditioning Condenser Replacement.
  6. Evacuate and charge the refrigerant system. Refer to Refrigerant Recovery and Recharging.
  7. Leak test the fittings using the GE 39400-A detector .
Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement (LUV)
Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement Callout Component Name 1 Air Conditioning Refrigerant Pre ...

Air Conditioning Clutch Assembly Replacement (LDE/LUW/LWE)
Air Conditioning Clutch Assembly Replacement Callout Component Name Preliminary Procedure Remove the air conditioning compresso ...

Other materials:

Radio Controls with Touchscreen
Audio Source Menu VOL (Volume): Press to increase or decrease the volume. (Power): Press and hold to turn the system on and off. (Home Page): Press to enter the Home Page. ...

Electrical System Overload
The vehicle has fuses and circuit breakers to protect against an electrical system overload. When the current electrical load is too heavy, the circuit breaker opens and closes, protecting the circuit until the current load returns to normal or the problem is fixed. This greatly reduces the c ...

Hood Adjustment
Hood Adjustment Callout Component Name 1 Hood Caution: Refer to Fastener Caution. Procedure Loosen the 4 hood hinge nuts. Adjust the hood in order to obtain an even gap on both sides between ...

В© 2014-2022 Copyright www.csmans.com
 
0.0069