Chevrolet Sonic manuals
 

Chevrolet Sonic Repair Manual: Air Conditioning Compressor and Condenser Hose Replacement (LDE/LWE)

Chevrolet Sonic Repair Manual / HVAC / Cooling / Air Conditioning Compressor and Condenser Hose Replacement (LDE/LWE)

Removal Procedure
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
  2. Disconnect the A/C refrigerant pressure sensor electrical connector.

  3. Remove air conditioning compressor and condenser hose nut (1).
  4. Remove air conditioning compressor and condenser hose (2) from A/C condenser.

  5. Remove A/C compressor and condenser hose bolts (1).
  6. Remove A/C compressor and condenser hose (2) from A/C compressor.

  7. Remove air conditioning compressor and condenser hose nut (1).
  8. Remove air conditioning compressor and condenser hose (2) from refrigerant hose.
  9. Remove air conditioning compressor and condenser hose from the vehicle.
Installation Procedure

    Note:

    Use NEW system seals. Refer to Air Conditioning System Seal Replacement.

  1. Install air conditioning compressor and condenser hose.

    2. Caution:

    Refer to Fastener Caution.

  2. Install air conditioning compressor and condenser hose (2) to the refrigerant hose.
  3. Install air conditioning compressor and condenser hose nut (1). Tighten nut to 22 Y (16 lb ft)

    .



  4. Install air conditioning compressor and condenser hose (2) to the A/C compressor.
  5. Install air conditioning compressor and condenser hose bolts (1). Tighten bolt to 22 Y (16 lb ft)

    .



  6. Install air conditioning compressor and condenser hose (2) to the A/C condenser.
  7. Install air conditioning compressor and condenser hose nut (1). Tighten nut to 22 Y (16 lb ft)

    .

  8. Connect the A/C refrigerant pressure sensor electrical connector.
  9. Evacuate and charge the refrigerant system. Refer to Refrigerant Recovery and Recharging.
Air Conditioning Compressor Replacement (LUV)
Air Conditioning Compressor Replacement Callout Component Name Preliminary Procedure Recover the refrigerant. Refer to Refrigerant ...

Air Conditioning Compressor and Condenser Hose Replacement (LUV)
Removal Procedure Recover the refrigerant. Refer to Refrigerant Recovery and Recharging. Remove the drivetrain and front suspension frame skid plate if equipped. Refer to Drive ...

Other materials:

Headlamp Aiming
Visual Aiming Preparation Procedure Note: Some state and local laws specify requirements for headlamp aim. Comply with all of these laws when performing any headlamp aiming operations. Headlamp aim should be checked: When a new headlamp capsule is installed. If ser ...

Drive Range, Sixth Gear (Gen 1)
As vehicle speed increases, the transmission control module (TCM) processes input signals from the automatic transmission input and output speed sensors, the throttle position sensor and other vehicle sensors to determine the precise moment to command ON the normally-low 26 pressure control so ...

Lift Plate and Holding Fixture Removal
Lift Plate and Holding Fixture Removal Callout Component Name 1 DT-46625 Transmission Holding Fixture For equivalent regional tools, refer to Special Tools. Note: Raise the transmission in order to remov ...

В© 2014-2022 Copyright www.csmans.com
 
0.007