Chevrolet Sonic Repair Manual: Airbag Front Passenger Presence Sensor Replacement

Chevrolet Sonic Repair Manual / Body / Restraints / Restraints Control / Airbag Front Passenger Presence Sensor Replacement

Airbag Front Passenger Presence Sensor Replacement
Callout	Component Name
Warning: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. Warning: To avoid personal injury, perform a preload test on the passenger presence system whenever you remove or replace the seat cushion trim. Failure to do so may cause the system to malfunction. Preliminary Procedure Remove the front passenger seat. Refer to Driver or Passenger Seat Removal and Installation. Remove the front seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement.
1	Passenger Seat Cushion Heater (if equipped) Procedure Disconnect the electrical connector. If either the seat cushion heater or one of the components of the passenger presence system need replacement, both the seat cushion heater and the complete passenger presence kit must be replaced.
2	Inflatable Restraint Passenger Presence System Procedures Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References. Program the inflatable restraint passenger presence system after replacement. Refer to Control Module References. Tip: The passenger presence system is an integral part of the pad on the passenger seat cushion. The sensor, module and seat cushion pad must be replaced as a unit. Note the routing of the wiring harness and connector location for installation.

Restraints Control

...

Airbag Instrument Panel Module Replacement

Airbag Instrument Panel Module Replacement Callout Component Name Warning: Refer to SIR Inflator Module Handling and Storage ...

Other materials:

Engine Heater
The engine heater can provide easier starting and better fuel economy during engine warm-up in cold weather conditions at or below −18°C (0°F). Vehicles with an engine heater should be plugged in at least four hours before starting. 1. Turn off the engine. 2. Open the hood and unwrap ...

Drive Range, Second Gear (Gen 2)
As vehicle speed increases and operating conditions become appropriate, the transmission control module (TCM) processes input signals from the automatic transmission input and output speed sensors, the throttle position sensor and other vehicle sensors to determine the precise moment to comman ...

4WD shift switch
Example Select the appropriate 4WD mode in the Nissan Armada by shifting the 4WD switch to AUTO, 4H, or 4L (if equipped), depending on current road and driving conditions. This flexibility allows the Nissan Armada to adapt to both on-road and off-road environments. When AUTO mode ...

0.0101