Chevrolet Sonic Repair Manual: Airbag Roof Side Rail Module Replacement - Rear

Chevrolet Sonic Repair Manual / Body / Restraints / Restraints Control / Airbag Roof Side Rail Module Replacement - Rear

Airbag Roof Side Rail Module Replacement - Rear
Callout	Component Name
Warning: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS. Warning: When installing the roof rail airbag, do not twist or turn the airbag 360?€‰degrees. Securing the roof rail airbag with an airbag twisted or turned 360?€‰degrees may cause the airbag not to deploy correctly and could cause personal injury. Warning: Refer to SIR Warning. Warning: Refer to SIR Inflator Module Handling and Storage Warning. Preliminary Procedures Disable the SIR system. Refer to SIR Disabling and Enabling It is only necessary to lower the headliner. Only do those steps in headliner replacement that will lower the headliner enough to gain access to the part. Refer to Headlining Trim Panel Replacement
1	Inflatable Restraint Roof Side Rail Module Retainer
2	Inflatable Restraint Roof Side Rail Module Fastener?€‰(Qty:?€‰4) Caution: Refer to Fastener Caution. Tighten 9.5?€‰Y?€‰(84?€‰lb?€‰in)
3	Inflatable Restraint Roof Side Rail Module Assembly Procedure Disconnect the electrical connector. Release the integral roof side rail module retainers. Remove the roof side rail inflatable restraint module from the vehicle. Refer to Inflatable Restraint Module Handling and Scrapping.

Airbag Instrument Panel Module Replacement

Airbag Instrument Panel Module Replacement Callout Component Name Warning: Refer to SIR Inflator Module Handling and Storage ...

Airbag Sensing and Diagnostic Module Replacement

Airbag Sensing and Diagnostic Module Replacement Callout Component Name Warning: Refer to SIR Warning. Warning: D ...

Other materials:

Brake Pressure Modulator Valve Bracket Replacement
Removal Procedure Remove the brake pressure modulator valve (BPMV) and bracket assembly. Refer to Brake Pressure Modulator Valve Replacement. Remove the BPMV bolts (1). Remove the BPMV bracket. Installation Procedure Install the BPMV br ...

Transmission Component and System Description
The mechanical components of the 6T30/40/45/50 are as follows: A torque converter with an electronically controlled capacity clutch (ECCC) Gear-type fluid pump assembly 1??? and low and reverse clutch housing assembly 4?? and 3? reverse clutch housing assembly 2? clutch assem ...

Engine Flywheel Replacement
Engine Flywheel Replacement Callout Component Name Preliminary Procedure Remove the clutch pressure and driven Plate . Refer to Clutch Pressure and Driven Plate Replacement. Special Tools EN-652 Flywheel Holder ...

0.0105