Chevrolet Sonic Repair Manual: Airbag Roof Side Rail Module Replacement - Rear

Chevrolet Sonic Repair Manual / Body / Restraints / Air Bag Modules / Airbag Roof Side Rail Module Replacement - Rear

Airbag Roof Side Rail Module Replacement - Rear
Callout	Component Name
Warning: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS. Warning: When installing the roof rail airbag, do not twist or turn the airbag 360?€‰degrees. Securing the roof rail airbag with an airbag twisted or turned 360?€‰degrees may cause the airbag not to deploy correctly and could cause personal injury. Warning: Refer to SIR Warning. Warning: Refer to SIR Inflator Module Handling and Storage Warning. Preliminary Procedures Disable the SIR system. Refer to SIR Disabling and Enabling It is only necessary to lower the headliner. Only do those steps in headliner replacement that will lower the headliner enough to gain access to the part. Refer to Headlining Trim Panel Replacement
1	Inflatable Restraint Roof Side Rail Module Retainer
2	Inflatable Restraint Roof Side Rail Module Fastener?€‰(Qty:?€‰4) Caution: Refer to Fastener Caution. Tighten 9.5?€‰Y?€‰(84?€‰lb?€‰in)
3	Inflatable Restraint Roof Side Rail Module Assembly Procedure Disconnect the electrical connector. Release the integral roof side rail module retainers. Remove the roof side rail inflatable restraint module from the vehicle. Refer to Inflatable Restraint Module Handling and Scrapping.

Airbag Instrument Panel Module Replacement

Airbag Instrument Panel Module Replacement Callout Component Name Warning: Refer to SIR Inflator Module Handling and Storage ...

Airbag Sensing and Diagnostic Module Replacement

Airbag Sensing and Diagnostic Module Replacement Callout Component Name Warning: Refer to SIR Warning. Warning: D ...

Other materials:

Body Hinge Pillar Lower Reinforcement Replacement
Removal Procedure Warning: Refer to Approved Equipment for Collision Repair Warning. Disable the SIR system. Refer to SIR Disabling and Enabling. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove all ...

Strut, Strut Component, or Spring Replacement
Disassembly Procedure Remove the strut assembly from the vehicle. Refer to Strut Assembly Removal and Installation. Note: The spring is compressed when the strut moves freely. Install the strut assembly (2) in a suitable spring compressor ...

Cylinder Head Disassemble
Special Tools EN-840 Pliers/Remover EN-8062 Valve Spring Compressor EN-8062-5 Adapter EN-50717-2 Compressor Assembly of EN-50717 Kit For equivalent regional tools, refer to Special Tools. Install the EN-50717?E assembly (1) to the EN-8062 compressor (4). Install the E ...

0.0071