Chevrolet Sonic Repair Manual: Airbag Roof Side Rail Module Replacement - Rear

Chevrolet Sonic Repair Manual / Body / Roof - Fixed, Leisure / Airbag Roof Side Rail Module Replacement - Rear

Airbag Roof Side Rail Module Replacement - Rear
Callout	Component Name
Warning: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS. Warning: When installing the roof rail airbag, do not twist or turn the airbag 360?€‰degrees. Securing the roof rail airbag with an airbag twisted or turned 360?€‰degrees may cause the airbag not to deploy correctly and could cause personal injury. Warning: Refer to SIR Warning. Warning: Refer to SIR Inflator Module Handling and Storage Warning. Preliminary Procedures Disable the SIR system. Refer to SIR Disabling and Enabling It is only necessary to lower the headliner. Only do those steps in headliner replacement that will lower the headliner enough to gain access to the part. Refer to Headlining Trim Panel Replacement
1	Inflatable Restraint Roof Side Rail Module Retainer
2	Inflatable Restraint Roof Side Rail Module Fastener?€‰(Qty:?€‰4) Caution: Refer to Fastener Caution. Tighten 9.5?€‰Y?€‰(84?€‰lb?€‰in)
3	Inflatable Restraint Roof Side Rail Module Assembly Procedure Disconnect the electrical connector. Release the integral roof side rail module retainers. Remove the roof side rail inflatable restraint module from the vehicle. Refer to Inflatable Restraint Module Handling and Scrapping.

Roof - Fixed, Leisure

...

Roof Front Header Panel Replacement

Removal Procedure Warning: Refer to Approved Equipment for Collision Repair Warning. Note: The roof front header panel is made of Ultra High Strength Steel and ...

Other materials:

Instrument Panel Center Upper Molding Replacement
Instrument Panel Center Upper Molding Replacement Callout Component Name Preliminary Procedure Remove the instrument panel center molding. Refer to Instrument Panel Center Molding Replacement. 1 ...

Outside Mirror Description and Operation
Power Mirror System Components The power mirror system consists of the following components: Outside rearview mirror switch Mirror selector switch Driver outside rearview mirror Passenger outside rearview mirror Each of the outside rearview mirror contains two motors. Th ...

Input Shaft Support Replacement (Gen 1)
Input Shaft Support Replacement Callout Component Name 1 3-5 Reverse and 4-5-6 Clutch Fluid Seals (Qty: 4) Note: Discard the fluid seals. They are not reusable. Refer to 3-5-Reverse an ...

0.0055