Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Airbag Side Impact Sensor Replacement (with AYF/AYO)

Chevrolet Sonic Repair Manual / Body / Restraints / Air Bag Modules / Airbag Side Impact Sensor Replacement (with AYF/AYO)



Airbag Side Impact Sensor Replacement

Callout

Component Name

Warning:

Refer to SIR Warning.

Warning:

Refer to SIR Inflator Module Handling and Storage Warning.

Warning:

Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:

  • The seat cushion frame
  • The seat recliner, if equipped
  • The seat adjuster
  • The seat back frame

Failure to do so may cause future personal injury.

Preliminary Procedures

  1. Disable the SIR system. Refer to SIR Disabling and Enabling.
  2. Remove the center pillar lower trim panel. Refer to Center Pillar Lower Trim Panel Replacement.

1

Inflatable Restraint Side Impact Sensor Assembly

Caution:

Refer to Fastener Caution.

Procedure

  1. Disconnect electrical connector.
  2. Loosen the fasteners and slide the sensor out of the keyhole slots.
  3. The bolts are integral to the sensor assembly, DO NOT remove separately.
Tighten


7.5?€‰Y (66?€‰lb?€‰in)

Airbag Sensing and Diagnostic Module Replacement
Airbag Sensing and Diagnostic Module Replacement Callout Component Name Warning: Refer to SIR Warning. Warning: D ...

Airbag Steering Wheel Module Coil Centering
Note: If a double wire harness strap is installed onto the wire harness assembly and steering column, the original holder for the wire strap(s) MUST be reused during installation. ...

Other materials:

Shoulder Belt Height Adjuster
The vehicle has a shoulder belt height adjuster for the driver and right front passenger seating positions. Adjust the height so the shoulder portion of the belt is on the shoulder and not falling off of it. The belt should be close to, but not contacting, the neck. Improper shoulder belt hei ...

Charging System Light
This light will come on briefly when the ignition is turned on, and the engine is not running, as a check to show it is working. It should go out when the engine is started. If it stays on, or comes on while driving, there may be a problem with the electrical charging system. Have it checked ...

Brake Rotor Refinishing
Special Tools CH-41013 Rotor Resurfacing Kit CH-42450-A Wheel Hub Resurfacing Kit For equivalent regional tools, refer to Special Tools. Warning: Refer to Brake Dust Warning. Note: The disc brake rotors do not require refinishing as part of routine brake system servic ...

© 2014-2024 Copyright www.csmans.com
 
0.0075