Chevrolet Sonic Repair Manual: Airbag Steering Wheel Module Replacement
- Removal Procedure
-
- Disable the SIR system. Refer to SIR Disabling and Enabling.
- Rotate the steering wheel 180?€‰degrees.
- Using a blunt-ended tool, push the spring fastener inward through the access hole?€‰(1) located on the rear of the steering wheel by pulling the tool outwards.
- Keeping the tool inserted, repeat the step for other opening.
- Keeping the upper step pull the steering wheel inflatable restraint module out of the steering wheel.
- Disconnect the electrical connectors.
- Remove the steering wheel inflatable restraint module.
Warning:
Refer to SIR Inflator Module Handling and Storage Warning.
Warning:
Refer to SIR Warning.
- Installation Procedure
-
- Connect the electrical connectors.
- Align the steering wheel module fasteners to the steering column fastener holes.
- Push the steering wheel module?€‰(1) firmly into the steering column in order to engage the fasteners.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
- Refer to Inflatable Restraint Module Handling and Scrapping.
Airbag Steering Wheel Module Coil Centering
Note: If a double wire harness strap is installed onto the wire
harness assembly and steering column, the original holder for the wire strap(s)
MUST be reused during installation.
...
Driver or Passenger Seat Shoulder Belt Replacement (with A69)
Driver or Passenger Seat Shoulder Belt Replacement
Callout
Component Name
Warning: Refer to SIR Warning.
Warning: ...
Other materials:
Tire and Wheel Removal and Installation
Special Tools
CH-41013 Rotor Resurfacing Kit
CH-42450-A Wheel Hub Resurfacing Kit
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the wheel cover, if equipped.
...
Rear Wheelhouse Liner Replacement (Sedan - Right)
Rear Wheelhouse Liner Replacement
Callout
Component Name
Preliminary Procedure
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and
Installation.
1
Rear Wheelhouse Panel Liner ...
Input Speed Sensor Replacement
Removal Procedure
Remove the control solenoid valve and transmission
control module assembly. Refer to Control Solenoid
Valve and Transmission Control Module Assembly Replacement.
Remove the input speed sensor bolt (2) M6 x 23.
Unlock t ...
0.0081