Chevrolet Sonic Repair Manual: Airbag Steering Wheel Module Replacement
- Removal Procedure
-
- Disable the SIR system. Refer to SIR Disabling and Enabling.
- Rotate the steering wheel 180?€‰degrees.
- Using a blunt-ended tool, push the spring fastener inward through the access hole?€‰(1) located on the rear of the steering wheel by pulling the tool outwards.
- Keeping the tool inserted, repeat the step for other opening.
- Keeping the upper step pull the steering wheel inflatable restraint module out of the steering wheel.
- Disconnect the electrical connectors.
- Remove the steering wheel inflatable restraint module.
Warning:
Refer to SIR Inflator Module Handling and Storage Warning.
Warning:
Refer to SIR Warning.
- Installation Procedure
-
- Connect the electrical connectors.
- Align the steering wheel module fasteners to the steering column fastener holes.
- Push the steering wheel module?€‰(1) firmly into the steering column in order to engage the fasteners.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
- Refer to Inflatable Restraint Module Handling and Scrapping.
Airbag Steering Wheel Module Coil Centering
Note: If a double wire harness strap is installed onto the wire
harness assembly and steering column, the original holder for the wire strap(s)
MUST be reused during installation.
...
Front Seat Outboard Seat Back Airbag Replacement
Front Seat Outboard Seat Back Airbag Replacement
Callout
Component Name
Warning: Following the deployment of a side impact air ...
Other materials:
Engine Oil Pressure Light
Caution
Lack of proper engine oil maintenance can damage the engine. Driving with
the engine oil low can also damage the engine. The repairs would not be covered
by the vehicle warranty. Check the oil level as soon as possible. Add oil if required,
but if the oil level is within the operating ...
Cleaning High Gloss Surfaces and Vehicle Information and Radio Displays
For vehicles with high gloss surfaces or vehicle displays, use a microfiber cloth
to wipe surfaces. Before wiping the surface with the microfiber cloth, use a soft
bristle brush to remove dirt that could scratch the surface. Then use the microfiber
cloth by gently rubbing to clean. Never use w ...
Brake Pedal Assembly Replacement
Removal Procedure
Remove the battery tray. Refer to Battery Tray Replacement.
Remove the power vacuum brake booster bolts (1).
Remove the brake pedal assembly upper nuts (1)
Remove the brake pedal assembly lower nuts (1)
Remo ...
0.0058