Chevrolet Sonic Repair Manual: Airbag Steering Wheel Module Replacement
- Removal Procedure
-
- Disable the SIR system. Refer to SIR Disabling and Enabling.
- Rotate the steering wheel 180 degrees.
- Using a blunt-ended tool, push the spring fastener inward through the access hole (1) located on the rear of the steering wheel by pulling the tool outwards.
- Keeping the tool inserted, repeat the step for other opening.
- Keeping the upper step pull the steering wheel inflatable restraint module out of the steering wheel.
- Disconnect the electrical connectors.
- Remove the steering wheel inflatable restraint module.
Warning:
Refer to SIR Inflator Module Handling and Storage Warning.
Warning:
Refer to SIR Warning.
- Installation Procedure
-
- Connect the electrical connectors.
- Align the steering wheel module fasteners to the steering column fastener holes.
- Push the steering wheel module (1) firmly into the steering column in order to engage the fasteners.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
- Refer to Inflatable Restraint Module Handling and Scrapping.
Airbag Steering Wheel Module Coil Centering
Note: If a double wire harness strap is installed onto the wire
harness assembly and steering column, the original holder for the wire strap(s)
MUST be reused during installation.
...
Intermediate Steering Shaft Replacement
Intermediate Steering Shaft Replacement
Callout
Component Name
Preliminary Procedure
Remove the steering column and the interme ...
Other materials:
Sunroof Housing Front Drain Hose Replacement
Sunroof Housing Front Drain Hose Replacement
Callout
Component Name
Preliminary Procedure
It is only necessary to lower the headliner. Only do those steps in the
headliner replacement procedure that will lower the headliner ...
Turbocharger Installation
Special Tool
EN-49942 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces.
Replace the connect fittings on the turbocharger coolant feed pipe and the
turbocharger coolant return pipe. Refer to Turbocharger Disassemble and Turbocharger
Ass ...
Charge Air Cooler Outlet Air Hose Replacement
Removal Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
Loosen the clamp (1) at the charge air cooler outlet pipe (2) to throttle
body (3).
Disconnect the intake air pressure and temperature sensor harness connect ...
0.0064