
|
Callout |
Component Name |
|---|---|
Preliminary Procedures
|
|
|
1 |
Ambient Air Temperature Sensor Procedure
|
Mode Control Cable Replacement (LHD)Operation
Radio Controls without Touchscreen
The infotainment system is operated by using the pushbuttons, multifunction
knobs, menus shown on the display, and steering wheel controls, if equipped.
Turning the System On or Off
O /VOL (Power/Volume)
Press to turn t ...
Fog Lamp Aiming
Preparation Procedure
Note: Horizontal aim is not adjustable on this vehicle. Vertical
aim is done by an adjusting nut located on the rear of the fog lamp. Prior
to aiming the fog lamps, perform the following steps:
Completely assemble all of the components on the vehi ...
Relay Replacement (Attached to Wire Harness)
Removal Procedure
Locate the relay. Refer to the Master Electrical Component List to locate
the relay in the vehicle.
Remove any fasteners which hold the relay in place.
Remove any connector position assurance (CPA) devices or secondary locks.
Note: Use care w ...