1. Close all doors, the trunk/liftgate, and the hood.
2. Lock the vehicle in one of two ways:
on the
3. After 30 seconds the alarm system will arm, and the indicator light will begin
to slowly flash indicating the alarm system is operating. Pressing
on the RKE transmitter a second time
will bypass the 30-second delay and immediately arm the alarm system.
The vehicle alarm system will not arm if the doors are locked with the key.
If the driver door is opened without first unlocking with the RKE transmitter,
the horn will chirp and the lights will flash to indicate pre-alarm. If the vehicle
is not started, or the door is not unlocked by pressing
on the RKE transmitter during the 10–second
pre-alarm, the alarm will be activated.
If a door, the hood, or the liftgate is opened without first unlocking with the RKE transmitter, the turn signals will flash and the horn will sound for about 30 seconds. The alarm system will then re-arm to monitor for the next unauthorized event.
Vehicle Alarm System
Disarming the SystemBattery Positive Cable Replacement
Removal Procedure
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove the underhood fuse block cover.
Remove the battery positive nut (1) and the battery positive cable (2),
from the underhood fus ...
Battery Inspection/Test
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic
procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic approach.
Diagnostic Procedure Instructions provides an overview of each diagnostic
catego ...
Engine Replacement (Manual Transmission)
Special Tools
J-45859 Wheel Drive Shaft Remover .
CH-807 Closure Plugs .
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the battery and battery tray. Refer to Battery Tray Replacement.
Relieve the fuel system pressure. Refer to Fu ...