Chevrolet Sonic Owner's Manual: Automatic Door Locks

Chevrolet Sonic Owner's Manual / Keys, Doors, and Windows / Keys and Locks / Automatic Door Locks

The vehicle is programmed so that when the doors are closed, the ignition is on, and the shift lever is moved out of P (Park) for automatic transmissions, or when the vehicle speed is above 13 km/h (8 mph) for manual transmissions, the doors and the trunk/liftgate will lock.

To unlock the doors and the trunk/ liftgate press switch. on the center stack or the driver door
switch.

If equipped with an automatic transmission the vehicle must be in P (Park).

If equipped with a manual transmission the vehicle must be in Neutral with the parking brake set.

This feature can be programmed. See Vehicle Personalization.

Delayed Locking

This feature delays the actual locking of the doors until five seconds after all doors are closed. Delayed locking can only be turned on when the Unlocked Door Anti Lockout feature has been turned ...

Lockout Protection

If the driver side power door lock switch is pressed when the driver door is open and the key is in the ignition, all of the doors will lock and then the driver door will unlock. If Unlocked Door ...

Other materials:

Starter Switch Check
Warning When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured. 1. Before starting this check, be sure there is enough room around the vehicle. 2. Apply both the parking brake and the regular brake. Do not use the accelerator p ...

Wheel Replacement
Replace any wheel that is bent, cracked, or badly rusted or corroded. If wheel nuts keep coming loose, the wheel, wheel bolts, and wheel nuts should be replaced. If the wheel leaks air, replace it. Some aluminum wheels can be repaired. See your dealer if any of these conditions exist. Your de ...

Adhesive Installation of Rear Windows
Warning: Refer to Glass and Sheet Metal Handling Warning. Use a urethane adhesive systems which meet GM Specification GM?€‰3651G. Remove all mounds or loose pieces of urethane adhesive from the pinchweld area. If the original window is being reused, remove all but approxi ...

0.01