Chevrolet Sonic Repair Manual: Automatic Transmission Flex Plate Installation
Special Tools
EN-652 Automatic Transmission Flex Plate Holder
For equivalent regional tools, refer to Special Tools.
- Clean the automatic transmission flex plate bolt threads.
- Install the automatic transmission flex plate (2) and the EN-652 holder to hold the automatic transmission flex plate (2).
- Install the 6 NEW automatic transmission flex plate bolts (2)
and tighten the bolts to 60 Y (44 lb ft)
.
- Remove the EN-652 holder.
Caution:
Refer to Fastener Caution.
Automatic Transmission Control Indicator Opening Cover Replacement
Automatic Transmission Control Indicator Opening Cover Replacement
Callout
Component Name
Preliminary Procedure
Remove the fron ...
Automatic Transmission Flex Plate Removal
Special Tools
EN-652 Automatic Transmission Flex Plate Holder
For equivalent regional tools, refer to Special Tools.
Install the EN-652 holder (1) to hold the automatic
trans ...
Other materials:
Rear Compartment Lid Weatherstrip Replacement
Rear Compartment Lid Weatherstrip Replacement
Callout
Component Name
1
Rear Compartment Lid Weatherstrip
Procedure
Disconnect any electrical connector.
Clean the area where the seal will be mounted. Use a suit ...
Engine Front Cover Gasket Installation
Clean the sealing surfaces and remove all remains of old sealing compound
material.
Note: The thickness of the sealing bead should be 2 mm (0.0787 in).
Apply sealing compound to the shown areas (1) and (2). Refer to Adhesives,
Fluids ...
Bushing and Mating Shaft Inspection
Note: Proper bushing and corresponding mating shaft inspection should
be performed before replacing the bushing, shaft, and in some cases, the component
which houses the bushing. Thoroughly clean and dry the bushing and shaft surfaces
before inspecting for damage.
Any of the followin ...
0.0047