Chevrolet Sonic Repair Manual: Automatic Transmission Shift Lock Control Function Check
Warning:
When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured.
- Before starting this check, be sure there is enough room around the vehicle. It should be parked on a level surface.
- Apply the parking brake. Be ready to apply the regular brake immediately if the vehicle begins to move.
- With the engine off, turn the ignition on, but do not start the engine. Without applying the regular brake, try to move the shift lever out of P (Park) with normal effort. If the shift lever moves out of P (Park), contact your dealer for service.
Automatic Transmission Shift Lock Control Description and Operation
The automatic transmission park lock control system is a safety device that prevents
an inadvertent shift out of PARK. The driver must press the brake pedal before moving
the park lever out of the ...
Bushing and Mating Shaft Inspection
Note: Proper bushing and corresponding mating shaft inspection should
be performed before replacing the bushing, shaft, and in some cases, the component
which houses the bushing. Thoroughly c ...
Other materials:
Piston, Connecting Rod, and Bearing Installation
Special Tools
EN-470-B Angular Torque Wrench
For equivalent regional tools, refer to Special Tools.
Adjust the piston ring joints as follows:
Upper compression ring (1).
Lower compression ring (4).
Oil rings (2) or (3).
Oil ring spacer (5). ...
Fuel Tank Replacement
Removal Procedure
Disconnect the battery negative cable. Refer to
Battery Negative Cable Disconnection and Connection.
Relieve the fuel pressure. Refer to
Fuel Pressure Relief.
Drain the fuel Tank. Refer to
Fuel Tank Draining.
Lift and support the vehicle. Refer ...
Clutch System Description and Operation
Clutch Spin Down Time
Inspect the clutch spin down time as follows:
Apply the parking brake and block the vehicle wheels.
Shift the manual transmission into NEUTRAL.
Start the engine. Run the engine at idle speed.
Engage the clutch.
Disengage the clutch. Wait 9 seconds.
...
0.0067