Driveline
Hub/Axle Flange and Wheel Stud Runout InspectionTire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...
Battery Disconnect Warning
Warning: Unless directed otherwise, the ignition and start switch
must be in the OFF or LOCK position, and all electrical loads must be OFF before
servicing any electrical component. Disconnect the negative battery cable to
prevent an electrical spark should a tool or equipment come in c ...
Range Selector Lever Cable Bracket Replacement
Removal Procedure
Set the park brake and chock the wheels.
Disconnect the range selector cable end (1) from the
range selector lever.
Disconnect the range selector cable (2) from the range
selector cable bracket.
Remove the transmission rang ...