Chevrolet Sonic Repair Manual: Backup Lamp Switch Replacement
- Removal Procedure
-
- Disconnect the electrical connector from the backup lamp switch?€‰(1).
- Remove the backup lamp switch?€‰(1) from the transmission.
- Remove and DISCARD the backup lamp switch washer from the backup lamp switch.
- Installation Procedure
-
- Install a NEW backup lamp switch washer on the backup lamp switch?€‰(1).
- Install the backup lamp switch?€‰(1) into the transmission case, and
tighten to 20?€‰Y (15?€‰lb?€‰ft).
- Connect the electrical connector to the backup lamp switch?€‰(1).
Caution:
Refer to Component Fastener Tightening Caution.
Backup Lamp Switch Replacement
Backup Lamp Switch Replacement
Callout
Component Name
Preliminary Procedure
Disconnect the negative battery cable. Refer to Battery ...
Fog Lamp Aiming
Preparation Procedure
Note: Horizontal aim is not adjustable on this vehicle. Vertical
aim is done by an adjusting nut located on the rear of the fog lamp. Prior
to aiming the fog ...
Other materials:
Replacement Wheels Description
Replace the wheel if any of the following conditions exist:
The wheel exhibits excessive runout.
The wheel is bent.
The wheel is cracked.
The wheel is severely rusted.
The wheel is severely corroded.
Note: Air leaks caused by porosity on aluminum wheels are repairable.
...
Transmission Assemble (Gen 2)
Special Tools
3-9506289 Universal Adapter
R-0007758 Holding Fixture
S-9407197 Differential Rotating Tool
S-9407198 Differential Bearing Race Wrench
For equivalent regional tools, refer to Special Tools.
Install the clutch and differential housing assembly (1)
onto ...
Synchronizers Disassemble
1st/2nd Gear Synchronizer
iv
Note: When servicing the synchronizers, retain them in the
same order that they are removed. Keep the synchronizer components together
and mark them to identify correct location.
Remove the 1st/2nd gear synchronizer hub ...
0.0056