Chevrolet Sonic manuals
 

Chevrolet Sonic Repair Manual: Battery Positive and Negative Cable Replacement

Chevrolet Sonic Repair Manual / Powertrain / Engine / General / Battery Positive and Negative Cable Replacement

Removal Procedure
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  2. Remove the fuse block and battery positive cable cover.
  3. Remove the battery tray. Refer to Battery Tray Replacement.


  4. Remove the battery positive nut (1) and the battery positive cable (2), from the battery positive cable junction block.

  5. Remove the battery negative cable nut (1) and the battery negative cable (2), from the chassis frame stud.
  6. Remove the drivetrain and front suspension frame skid plate. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement.


  7. Remove the battery positive cable nut (2) and the battery positive cable (3), from the back of the generator.

  8. Remove the battery negative cable stud/nut (1) and the starter solenoid nut (2).

    9. Note:

    Visualize the routing of the battery positive and negative cable within the engine compartment.

  9. Remove the battery positive and negative cable (1) from the engine compartment.
Installation Procedure


    Caution:

    Refer to Fastener Caution.

  1. Install the battery positive cable (3) to the back of the generator and tighten nut (2) to 20 Y (15 lb ft)

    .



  2. Install the battery positive cable (3) to the starter solenoid and tighten nut (2) to 12 Y (9 lb ft)

    .

  3. Install the battery negative cable to the starter and tighten the stud/nut (1) to 25 Y (18 lb ft)

    .

  4. Install the drivetrain and front suspension frame skid plate. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement.


  5. Install the battery negative cable nut (1) and the battery negative cable (2), to the chassis frame stud and tighten to 22 Y (16 lb ft)

    .



  6. Install the battery positive cable (2) to the battery positive cable extension cable junction block and tighten nut (1) to 12 Y (9 lb ft)

    .

  7. Install the battery tray. Refer to Battery Tray Replacement.
  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  9. Install the fuse block and battery positive cable cover.
Battery Positive Cable Replacement
Removal Procedure Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the underhood fuse block cover. Remove the ...

Battery Replacement
Removal Procedure Open the hood. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the battery retainer bo ...

Other materials:

DIC Menu Items
Press MENU to view the DIC menus. Some items display in the upper display area, some in the lower display area, and others use both the upper and lower display areas. Use to scroll through the menu items. Not all items are available on every vehicle. The following is a list of all possible ...

Generator Replacement (LUV)
Removal Procedure Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the drive belt. Refer to Drive Belt Replacement. Remove the drive bel ...

Transmission Rear Mount Replacement
Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove and DISCARD the rear transmission mount bracket to rear mount through bolt (1). Remove rear transmission mount to frame bolt (3). Push and hold ...

В© 2014-2022 Copyright www.csmans.com
 
0.0069