Chevrolet Sonic Repair Manual: Battery Positive Cable Replacement

Chevrolet Sonic Repair Manual / Powertrain / Engine / General / Battery Positive Cable Replacement

Removal Procedure

Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
Remove the underhood fuse block cover.

Remove the battery positive nut (1) and the battery positive cable (2), from the underhood fuse block.

Remove the battery positive cable nut (1) from the battery positive cable junction block.
Remove the battery positive cable (2) from the vehicle.

Installation Procedure

Caution:

Refer to Fastener Caution.

Install the battery positive cable (2) to the battery positive cable junction block and tighten nut (1) to 7 Y (62 lb in)
.

Install the battery positive cable (2) to the underhood fuse block and tighten nut (1) to 7 Y (62 lb in)
.
Install the underhood fuse block cover.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.

Battery Negative Cable Replacement

Battery Negative Cable Replacement Callout Component Name Preliminary Procedures Disconnect the battery current sensor connector. ...

Battery Positive and Negative Cable Replacement

Removal Procedure Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the fuse block and battery positive cable cover. ...

Other materials:

Wheel Replacement
Replace any wheel that is bent, cracked, or badly rusted or corroded. If wheel nuts keep coming loose, the wheel, wheel bolts, and wheel nuts should be replaced. If the wheel leaks air, replace it. Some aluminum wheels can be repaired. See your dealer if any of these conditions exist. Your d ...

Drive Belt Replacement
Special Tools EN-48488 Holding Wrench EN-955 Locking Pin For equivalent regional tools, refer to Special Tools. Removal Procedure Remove the right front wheelhouse liner extension. Refer to Front Wheelhouse Liner Inner Front Extension Replacement. Install the engine s ...

Manual Transmission Shift Lever Cable Adjustment
Special Tools DT-527-A Adjuster or 5mm drill bit For equivalent regional tools, refer to Special Tools. Note: Not using the specified tools may lead to shift system mis-adjustment. Remove the floor console. Refer to Front Floor Console Replacement. Lift upward an ...

0.0066