|
Callout |
Component Name |
|---|---|
Preliminary Procedures
|
|
|
1 |
Body Side Trim Panel Push-In Retainer |
|
2 |
Body Side Trim Panel Assembly Note: Ensure seat belt assembly is routed over and through opening in panel assembly. |
Body Rear Seat Back Trim Panel Replacement (with AMA/AM7)
Cargo Tie Down Loop ReplacementFront Wheel Speed Sensor Replacement
Removal Procedure
Warning: Refer to Brake Dust Warning.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal
and Installation.
Clean the wheel speed sensor mounting area on t ...
Throttle Body Heater Inlet Pipe Replacement (LUW)
Throttle Body Heater Inlet Pipe Replacement
Callout
Component Name
Preliminary Procedure
Drain the cooling system. Refer to Cooling System Draining and Filling.
1
Throttle Body Heater Inlet Pipe
...
Engine Coolant Thermostat Housing Installation
Caution: Refer to Engine Coolant Thermostat Housing Caution.
Clean sealing surface.
Install a NEW engine coolant thermostat housing seal.
Install the engine coolant thermostat housing (2).
Caution: Refer to Fastener Caution.
Note: Screw in the 4 ...