Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Brake Fluid Level Indicator Switch Replacement

Chevrolet Sonic Repair Manual / Chassis / Brakes / General / Brake Fluid Level Indicator Switch Replacement

Removal Procedure
  1. Disconnect the brake fluid level indicator switch electrical connector.

  2. Using a small, flat-bladed tool, lift the locking tab on the underside of the brake fluid level indicator switch (1) and remove the switch.
  3. Inspect the master cylinder reservoir for damage and replace, if necessary. Refer to Master Cylinder Reservoir Replacement.
Installation Procedure
  1. Install the master cylinder reservoir, if removed. Refer to Master Cylinder Reservoir Replacement.


  2. Install the brake fluid level indicator switch (1) by pressing the switch firmly into the brake master cylinder reservoir.
  3. Connect the brake fluid level indicator switch electrical connector.
Brake Fluid Irritant Warning
Warning: Brake fluid may irritate eyes and skin. In case of contact, take the following actions: Eye contact—rinse thoroughly with water. Skin contact—wash with soap and water. ...

Brake Fluid Warning
Warning: Use only Delco Supreme 11, GM P/N 12377967 (Canadian P/N 992667), or equivalent DOT 3 brake fluid from a clean, sealed container. Do not use fluid from ...

Other materials:

Camshaft Position Actuator Adjuster Removal
Special Tools EN-6340 Camshaft Adjuster Locking Tool EN-6628-A Camshaft Locking Tool For equivalent regional tools, refer to Special Tools. Note: The right half of the EN-6340 locking tool can be recognized by the lettering "right", arrow, on the tool. Pre ...

Throttle/Idle Learn
Description The engine control module (ECM) learns the airflow through the throttle body to ensure the correct idle. The learned airflow values are stored within the ECM. These values are learned to adjust for production variation and will continuously learn during the life of the ...

Park - Engine Running (Gen 2)
When the gear selector lever is in the Park (P) position, fluid is drawn into the pump through the transmission fluid filter assembly. Line pressure is then directed to the following valves: Fluid Pressure Directed in Preparation for a Shift Manual Valve Mechanically controlled ...

© 2014-2026 Copyright www.csmans.com
 
0.006