Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Brake Pedal Position Sensor Replacement

Chevrolet Sonic Repair Manual / Body / Body Electrical / Lighting / Brake Pedal Position Sensor Replacement

Removal Procedure
  1. Remove the instrument panel lower trim pad cover. Refer to Instrument Panel Lower Trim Pad Cover Replacement.


  2. Disconnect the brake pedal position sensor electrical connector.
  3. Remove the brake pedal position sensor bolt?€‰(1).
  4. Remove the brake pedal position sensor.
Installation Procedure


    Note:

    Ensure the fork of the brake pedal position sensor is positioned over the brake pedal post.

  1. Install the brake pedal position sensor to the brake pedal bracket.
  2. Caution:

    Refer to Fastener Caution.

  3. Install the brake pedal position sensor bolt?€‰(1)?€‰and tighten to?€‰ 3?€‰Y (27?€‰lb?€‰in)

    .

  4. Connect the brake pedal position sensor electrical connector.
  5. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration.
  6. Install the instrument panel lower trim pad cover. Refer to Instrument Panel Lower Trim Pad Cover Replacement.
Brake Pedal Position Sensor Calibration
Calibration Criteria Note: Do not apply the brake pedal during the brake pedal position sensor calibration procedure. Any movement of the brake pedal during this procedure will ca ...

Bulbs
...

Other materials:

Windows
Warning Never leave a child, a helpless adult, or a pet alone in a vehicle, especially with the windows closed in warm or hot weather. They can be overcome by the extreme heat and suffer permanent injuries or even death from heat stroke. The vehicle aerodynamics are designed to improve fuel ...

Roof Rail Front Assist Handle Replacement
Roof Rail Front Assist Handle Replacement Callout Component Name 1 Roof Rail Front Assist Handle Fastener (Qty:?€‰2) Caution: Refer to Fastener Caution. Procedure Fold the assist handle downward ...

Drive Range, Fifth Gear Default (Gen 2)
If the transmission encounters an electrical component malfunction, the transmission will default to Fourth gear. All solenoids will default to their normal state. If the torque converter clutch is applied, it will release. The transmission will remain in Drive Range?Fourth Gear Default until ...

© 2014-2026 Copyright www.csmans.com
 
0.0045