Chevrolet Sonic Repair Manual: Brake Rotor Surface and Wear Inspection

Chevrolet Sonic Repair Manual / Chassis / Brakes / Disc Brakes / Brake Rotors / Brake Rotor Surface and Wear Inspection

Warning:

Refer to Brake Dust Warning.

If the inboard friction surface of the brake rotor is not accessible, reposition and support the caliper with the brake pads. Refer to Front Disc Brake Pads Replacement.
Clean the friction surfaces of the brake rotor with denatured alcohol, or an equivalent approved brake cleaner.
Inspect the friction surfaces of the brake rotor for the following braking surface conditions:

Heavy rust and/or pitting
Light surface rust can be removed with an abrasive disc. Heavy surface rust and/or pitting must be removed by refinishing the brake rotor.
Cracks and/or heat spots
Too much blueing discoloration

If the friction surfaces of the brake rotor exhibit one or more of the braking surface conditions, the brake rotor requires refinishing or replacement.

Using a micrometer (1) calibrated in thousandths-of-a-millimeter, or ten-thousandths-of-an-inch, measure and record the scoring depth of any grooves present on the brake rotor friction surfaces.

Compare the groove scoring depth recorded to the following specification: Specification

Brake rotor maximum allowable scoring: 1.50 mm (0.059 in) .

If the brake disc rotor scoring depth exceeds the specification, or if an excessive amount of scoring is present, the brake rotor requires refinishing or replacement.

Brake Rotor Refinishing

Special Tools CH-41013 Rotor Resurfacing Kit CH-42450-A Wheel Hub Resurfacing Kit For equivalent regional tools, refer to Special Tools. Warning: Refer to Brake Dust Warning. Note ...

Brake Rotor Thickness Measurement

Warning: Refer to Brake Dust Warning. If the inboard friction surface of the brake rotor is not accessible, reposition and support the caliper with the brake pads. Refer to Front Disc Bra ...

Other materials:

Questions and Answers About Safety Belts
Q: Will I be trapped in the vehicle after a crash if I am wearing a safety belt? A: You could be— whether you are wearing a safety belt or not. Your chance of being conscious during and after a crash, so you can unbuckle and get out, is much greater if you are belted. Q: If my vehicle has ai ...

Rear Side Door Lock Cylinder Opening Cover Replacement
Rear Side Door Lock Cylinder Opening Cover Replacement Callout Component Name 1 Rear Side Door Lock Cylinder Opening Cover Procedure Remove the rear side door lock cylinder, Do Not remove the outside door han ...

Front Brake Shield Replacement
Removal Procedure Warning: Refer to Brake Dust Warning. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. Remove the front brake rotor. Refer to ...

0.0077