Chassis
GeneralRadio Programming and Setup
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the ECU is not properly configured with the correct
calibration software, the ECU will not control all of the vehicle features
properly.
Ensure the programming tool is ...
Lower Control Arm Replacement
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal
and Installation.
Remove the front wheelhouse rear liner. Refer to Front Wheelhouse Liner
Replacement.
Re ...
Warm Up Three-Way Catalytic Converter Removal
Disconnect the heated oxygen sensor wiring harness (3) from retainer clip.
Remove the 2 catalytic converter to catalytic converter bracket nuts (4)
and (6).
Loosen the three way warm up catalytic converter V-clamp (1).
Remove the three way warm up ...