For the proper type of replacement bulbs, see Replacement Bulbs.
For any bulb‐changing procedure not listed in this section, contact your dealer.
Bulb Replacement
Halogen BulbsLock Cylinder Coding - Ignition
The ignition lock cylinder uses 8 key cut positions, 1–8. The ignition cylinder
tumblers (3) are located on alternate sides of the cylinder (5). They are not snap-in
and are not self-retaining. It follows the key code with the first tumbler being
the first depth of the ...
Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
Special Tools
EL-49642 SPS Programming Support Tool
For equivalent regional tools, refer to Special Tools.
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the ECU is not properly configured with the correct
calibration ...
Clutch and Differential Housing Cleaning and Inspection
Warning: Wear safety glasses to avoid injury when using compressed
air or any cleaning solvent. Bodily injury may occur if fumes are inhaled
or if skin is exposed to chemicals.
Clean the clutch housing (1) with a suitable solvent.
Air dry all the parts.
Inspect ...