Chevrolet Sonic Repair Manual: Camshaft Cover Replacement

Chevrolet Sonic Repair Manual / Powertrain / Engine / Valvetrain / Camshaft / Camshaft Cover Replacement

Camshaft Cover Replacement
Callout	Component Name
Preliminary Procedures Remove the ignition coil. Refer to Ignition Coil Replacement. Remove the PCV hose. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replacement.
1	Camshaft Cover Fastener (Qty: 3) Caution: Refer to Fastener Caution. Note: Apply pipe sealant to the center bolt during reinstallation. Refer to Adhesives, Fluids, Lubricants, and Sealers. Tighten 8 Y (71 lb in)
2	Camshaft Cover Fastener (Qty: 8) Tighten 8 Y (71 lb in)
3	Camshaft Cover Gasket Procedure Do not reuse the camshaft gasket. Also use a new gasket when removing or replacing camshaft cover.
4	Camshaft Cover Procedure Remove or reposition the clips as necessary. Disconnect electrical connector as necessary. Transfer components as necessary.

Camshaft Cover Removal

Remove the oil level indicator (1). Remove the 15 camshaft cover bolts (1). Remove the camshaft cover (2) and the camshaft cover gasket (3). ...

Camshaft Installation

Special Tools EN-422 Installer For equivalent regional tools, refer to Special Tools. Note: Coat with MoS 2 lubricating paste. Refer to Adhesives, Fluids, Lubricants ...

Other materials:

Remote Control Door Lock Receiver Replacement
Remote Control Door Lock Receiver Replacement Callout Component Name Preliminary Procedure Remove the windshield outside moisture sensor cover. Refer to Windshield Outside Moisture Sensor Cover Replacement. ...

Rear Brake Caliper Replacement
Removal Procedure Warning: Refer to Brake Dust Warning. Warning: Refer to Brake Fluid Irritant Warning. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Install ...

Crankshaft Front Oil Seal Replacement
Special Tools EN-960 Installer EN-45000 Remover Oil seal For equivalent regional tools, refer to Special Tools. Removal Procedure Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement. Place a drain pan underneath the front crankshaft seal area. ...

0.0058