Chevrolet Sonic Repair Manual: Camshaft Position Actuator Solenoid Valve Installation
- Install the 2 camshaft position actuator solenoid valves (2) and the 2 seal rings (1) by carefully and evenly pressing.
- Install the 4 camshaft position actuator solenoid valve bolts (1) and tighten
to 8 Y (71 lb in)
.
- The 2 camshaft position actuator solenoid valves should be installed in the position as shown (1) and (2).
Caution:
The camshaft position actuator solenoid valves must be kept parallel to the engine front cover during removal and installation. The camshaft position actuator solenoid valves can be damaged if they become wedged or stuck during this process.
Caution:
Refer to Fastener Caution
Camshaft Position Actuator Adjuster Removal
Special Tools
EN-6340 Camshaft Adjuster Locking Tool
EN-6628-A Camshaft Locking Tool
For equivalent regional tools, refer to Special Tools.
Note: The right half of the EN-6340 ...
Camshaft Position Actuator Solenoid Valve Removal
Remove the camshaft position actuator solenoid valve bolts (1).
Remove the camshaft position actuator solenoid valves (2).
Remove the camshaft position actuator solenoid val ...
Other materials:
Drivetrain and Front Suspension Frame Replacement
Special Tools
EN-45059 Angle Meter
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Support the radiator and condenser from above using the upper brackets
on each side.
Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle.
Re ...
Brake Pressure Modulator Valve Pipe Replacement
Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning.
Caution: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution.
Caution: Always connect or disconnect the wiring harness connector
from the EBCM/EBTCM with the ignition switch ...
Battery Charging
Special Tools
EL 50313 Battery Tester
For equivalent regional tools, refer to Special Tools.
Diagnostic Aids
For best results, use an automatic taper-rate battery charger with a
voltage capability of 16 V.
The charging area should be well ventilated.
Do not charge a bat ...
0.1306