|
Callout |
Component Name |
|---|---|
|
1 |
Camshaft Position Sensor Fastener Caution: Refer to Fastener Caution.
6 Y (54 lb in) |
|
2 |
Camshaft Position Sensor Procedure
Disconnect electrical wiring harness connector from the camshaft position sensor. |
|
3 |
Remove the Camshaft Position Sensor Seal Ring |
Accelerator Pedal Position Sensor Replacement
Crankshaft Position Sensor ReplacementSiriusXM Radio Messages
UPDATING: The encryption code in the receiver is being updated, and no action
is required. This process should take no longer than 30 seconds.
NO SIGNAL: The system is functioning correctly, but the vehicle is in a location
that is blocking the SiriusXM signal. When the vehicle is moved into an ...
Repairing Damaged Wire Insulation
If the wire insulation has been chafed, or broken, enough to show the conductive
portion of the wire, and the wire is not damaged, determine the length of insulation
that needs to be repaired. If the repair is less than 280?€‰mm (11?€‰in), cut the
wire within the damaged area. Then sli ...
Wheel Drive Shaft Inner Joint Inspection
Inspection Procedure
Remove the front wheel drive shaft inner joint and boot. Refer to Front
Wheel Drive Shaft Replacement.
Remove the wheel drive shaft tripod bushing (1) from the tripod housing (3).
Remove the wheel drive shaft tripod housi ...