Chevrolet Sonic manuals
 

Chevrolet Sonic Repair Manual: Camshaft Replacement

Chevrolet Sonic Repair Manual / Powertrain / Engine / Valvetrain / Camshaft / Camshaft Replacement

Special Tools

EN-422 Installer

For equivalent regional tools, refer to Special Tools.

Removal Procedure


    Note:

    Take extreme care to prevent any scratches, nicks or damage to the camshafts and caps bearing surfaces.

  1. Remove the timing belt rear cover (1). Refer to Timing Belt Rear Cover Replacement.


  2. Remove the camshaft position solenoid valve housing bolts (1) and housing (2).

  3. Remove the camshaft cap bolts in sequence (1, 4, 2, 3).
  4. Remove the camshaft caps.

    5. Note:

    Mark the camshafts upon removal to ensure installation is in the correct position.

  5. Remove the exhaust camshaft (1) and intake camshaft (3) as necessary.

    6. Note:

    The camshaft seal MUST be replaced whenever the camshaft is removed.

  6. Remove exhaust camshaft seal (2) and intake camshaft seal (4) as necessary.
Installation Procedure
  1. Coat and lubricate the camshaft bearing and cam surfaces with clean engine oil.

    2. Note:

    It is essential to ensure that no sealant is applied outside the marked sealing areas.

  2. Apply sealant to the surface (1) of the 1st camshaft bearing cap.

  3. Install the exhaust camshaft (1) and intake camshaft (2) on the cylinder head.

    4. Caution:

    Refer to Fastener Caution.

  4. Install the camshaft bearing caps in sequence (2, 3, 1, 4) Tighten the camshaft bearing cap bolts to 8 Y (71 lb in)

    .



  5. Install the camshaft position solenoid valve housing (2) and camshaft position solenoid valve housing bolts (1). Tighten the bolts to 8 Y (71 lb in)

    .

  6. Install the new camshaft oil seal rings using EN-422 installer .


  7. Install the timing belt rear cover (1) and tighten the bolts (2) to 6 Y (53 lb in)

    . Refer to Timing Belt Rear Cover Replacement.

Camshaft Removal
Note: Note removal sequence 1?E. Remove the 4 camshaft bearing cap bolts. Note: Release the bearing support by striking it gently with a plastic hammer. ...

Exhaust Camshaft Installation
Note: Mind the markings on the camshaft bearing caps. Camshaft bearing caps should be installed in their original position. Lubricate camshaft and camshaft bearing caps with eng ...

Other materials:

OnStar Overview
If equipped, this vehicle has a comprehensive, in-vehicle system that can connect to a live Advisor for Emergency, Security, Navigation, Connection, and Diagnostic Services. The OnStar system status light is next to the OnStar buttons. If the status light is: Solid Green: System is read ...

Front Side Door Weatherstrip Replacement - Door Side
Front Side Door Weatherstrip Replacement - Door Side Callout Component Name 1 Front Side Door Weatherstrip Upper Retainer Procedure Open the front side door to the fully open position. Remove the front side do ...

Front License Plate Bracket Replacement
Front License Plate Bracket Replacement Callout Component Name Preliminary Procedure Remove the front license plate if equipped. 1 Front License Plate Bracket Screw (Qty:?€‰4) Caution: Re ...

© 2014-2026 Copyright www.csmans.com
 
0.0103