Chevrolet Sonic Repair Manual: Camshaft Seal Replacement
Special Tools
- EN 422 Installer
- EN 45000 Remover
For equivalent regional tools, refer to Special Tools
- Removal Procedure
-
- Remove the intake and exhaust camshaft sprocket. Refer to Camshaft Sprocket Replacement.
- Use the EN-45000 remover to loosen the camshaft front oil seals (1).
- Remove the camshaft front oil seals (1).
Note:
Do not damage the sealing surfaces.
- Installation Procedure
-
- Insert 2 NEW camshaft front oil seals (1).
- Tighten the seal ring with EN-422 installer (3) on the camshaft until this is in contact with the cylinder head.
- To install, use camshaft sprocket bolt (1) in conjunction with shims (2) with a total thickness of approximately 10 mm (0.393 in).
- Install the camshaft sprocket intake and exhaust. Refer to Camshaft Sprocket Replacement.
Crankshaft Front Oil Seal Installation
Special Tools
EN-6351 Mounting Sleeves
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces.
Slide the EN-6351 sleeves (2) protective sleeve onto t ...
Other materials:
Rear Window Replacement
Special Tools
BO-24402-A Glass Sealant Remover (Cold Knife)
BO-39032 Stationary Glass Removal Tool
Use an adhesive that is approved by GM
For equivalent regional tools, refer to Special Tools
Removal Procedure
Warning: If a window is cracked but still intact, crisscros ...
Front Seat Cushion Inner Trim Panel Replacement
Front Seat Cushion Inner Trim Panel Replacement
Callout
Component Name
1
Driver or Passenger Seat Inner Recliner Finish Cover Cap
Procedure
Use a flat-bladed tool to release the cap from the recliner cover.
...
Turbocharger Removal
Special Tool
EN-49942 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Install the EN-49942 holding wrench (2) to the turbocharger coolant
feed pipe. Guide a ratchet wrench (1) along with an extension through EN-49942
holding wrench to the turbo ...
0.0069